Influence of the Stand-off Distance and of the Layers Thickness on the Adhesion and Porosity of the 97MXC Deposits Obtained by Arc Spraying Process
Authors:
- R A HaragaRHR A Haraga
- D L ChicetDCD L Chicet
- N CimpoiesuNCN Cimpoiesu
- S L TomaSTS L Toma
- C BejinariuCBC Bejinariu
Open Access
- 1 June 2020
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 877 (1)
Abstract
In this paper, the surfaces of some weakly alloyed steel specimens were covered, by arc spraying process, with a layer of high alloyed steel: 97MXC, using core wires. The technological parameters, used to spray the high alloy steel, were kept constant except for the spray stand-off distance (SOD) which varied on three levels. The research was performed on deposits with a thickness between 0.2-2.4 mm. The microstructure of the deposits, the chemical composition, the physical properties of the layers were investigated by SEM analyzes, X-ray diffraction, microhardness tests and adhesion tests. The porosity of the deposits was determined by optical microscopy. The adhesion of the layer to the substrate was researched by the tensile test. Studies have shown the fact that SOD significantly influences the adhesion and porosity of the deposits. Thus, the increase of SOD determines the decrease of the adhesion of the layer to the substrate by approximately 21.4%, the increase of the porosity of the deposits by approximately 14.2% and variations up to 5% of the microhardness.Keywords
This publication has 27 references indexed in Scilit:
- In Situ Acoustic Monitoring of Thermal Spray Process Using High-Frequency Impulse MeasurementsJournal of Thermal Spray Technology, 2017
- Investigation of the Structure and Magnetic Properties of Bulk Amorphous FeCoYB AlloyRevista de Chimie, 2017
- Dispersive effects in laser ablation plasmasJapanese Journal of Applied Physics, 2014
- Design and Implementation of a Device for Nanostructuring of Metallic Materials by Multiaxial Forging MethodApplied Mechanics and Materials, 2014
- Experimental Determination of Force and Deformation Stress in Nanostructuring Aluminum by Multiaxial Forging MethodApplied Mechanics and Materials, 2014
- Practical Comparison of Cylindrical Nozzle and De Laval Nozzle for Wire Arc SprayingJournal of Thermal Spray Technology, 2014
- Effect of W dissolution in NiCrBSi–WC and NiBSi–WC arc sprayed coatings on wear behaviorsWear, 2014
- The influence of jet gas temperature on the characteristics of steel coating obtained by wire arc sprayingSurface and Coatings Technology, 2012
- The Science and Engineering of Thermal Spray Coatings2008
- Characterization of the W2C phase formed during the high velocity oxygen fuel spraying of a WC + 12 pct Co powderMetallurgical and Materials Transactions A, 1999