On the Hot Deformation of a Fe-Al-Ta Iron Aluminide Prepared via Laser Powder Bed Fusion
Open Access
Abstract
In the present work, a combined process of laser powder bed fusion (LPBF) and hot working in terms of microstructure refinement was investigated for Fe-25Al-1.5Ta alloy samples. Uniaxial compression tests were carried out parallel and perpendicular to the building direction (BD) at 1000 °C, where BCC A2-phase was stable, at a strain rate of 0.0013 s−1. The true stress–true strain curves indicated a broad flow stress peak followed by a slight decrease, which is typical for dynamic recrystallization (DRX) of conventional BCC metals such as ferritic iron. A negligible dependence in the flow stress behavior on the compression direction was observed. DRX initiated at a stress of 18.7 MPa for the sample compressed parallel to the BD, corresponding to a true strain of 0.011, and at 18.1 MPa for the samples compressed normal to the BD, which corresponded to a true strain of 0.010. The microstructural investigations by electron backscatter diffraction (EBSD) showed that the relatively coarse and elongated grains of the as-LPBF builds were significantly refined after hot working. The microstructure of the compressed samples mainly consisted deformed grains. These were fragmented by sub-grains bounded by low-angle boundaries independent of the compression axis, indicating the occurrence of dynamic recovery (DRV) during hot working. In addition, a few equiaxed, small grains were observed in the pre-existing grain boundaries, which formed due to DRX. Most pores in the as-LPBF builds were closed after hot compression, particularly in the central region of the deformed specimens where the compressive stress state is dominant. In summary, hot compression reveals a practical thermomechanical post-processing treatment for Fe-Al-Ta iron aluminides built by LPBF. The hot working refines the epitaxially elongated microstructure of the as-LPBF builds by DRV/DRX and reduces the porosity.Keywords
This publication has 43 references indexed in Scilit:
- Microstructures and mechanical properties of Fe–Al–Ta alloys with strengthening Laves phaseIntermetallics, 2011
- A Review of Strain Analysis Using Electron Backscatter DiffractionMicroscopy and Microanalysis, 2011
- Recent Developments Toward the Application of Iron Aluminides in Fossil Fuel TechnologiesAdvanced Engineering Materials, 2010
- Hot deformation and processing maps of an Fe3Al intermetallic alloyIntermetallics, 2006
- Predicting the Critical Stress for Initiation of Dynamic RecrystallizationISIJ International, 2006
- Strengthening of iron aluminide alloys by atomic ordering and Laves phase precipitation for high-temperature applicationsIntermetallics, 2005
- Iron–Aluminium-Base Alloys with Strengthening Laves Phase for Structural Applications at High TemperaturesMaterials Science Forum, 2005
- Processing of iron aluminidesMaterials Science and Engineering: A, 1998
- High-temperature deformation behaviour of Fe3AlMaterials Science and Engineering: A, 1998
- Dynamic recrystallization of ferrite in interstitial free steelScripta Materialia, 1997