Correlation of microstructures with creep and corrosion performance of Mg-5.0Al-2.0Ca-0.3Mn and MRI230D alloys
Authors:
- Purnendu NaskerPNPurnendu Nasker
- Rajaff AliRARajaff Ali
- S. KumarSKS. Kumar
- H. DieringaH. Dieringa
- A.K. MondalAMA.K. Mondal
- 5 May 2026
- journal article
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 360
Abstract
No abstract availableFunding Information
- Anusandhan National Research Foundation
- Department of Science and Technology, Ministry of Science and Technology, India (EEQ/2022/000195)
- Department of Science and Technology, Ministry of Science and Technology, India (16-12-2022)
This publication has 51 references indexed in Scilit:
- Tracing the Effects of Calcium, Stannum, and Zinc Additions on the Creep Resistance of Mg–Al-Based AlloysMetallurgical and Materials Transactions A, 2023
- Effect of Al/Mn ratio on corrosion behavior of lean Mg-Zn-Ca-Al-Mn alloy processed by twin-roll castingCorrosion Science, 2022
- Microstructural Investigation and High Temperature Mechanical Behavior of AXE622 Cast Mg AlloyMetals and Materials International, 2021
- Effect of Ca addition on the corrosion behavior of Mg–Al–Mn alloyApplied Surface Science, 2016
- Unexpected influence of Mn addition on the creep properties of a cast Mg–2Al–2Ca (mass%) alloyActa Materialia, 2011
- Impression Creep Behavior of a Cast AZ91 Magnesium AlloyMetallurgical and Materials Transactions A, 2008
- New magnesium alloys for transmission partsMetal Science and Heat Treatment, 2006
- Solidification paths and eutectic intermetallic phases in Mg–Al–Ca ternary alloysActa Materialia, 2005
- Creep Resistant Magnesium Alloys for Powertrain ApplicationsAdvanced Engineering Materials, 2003
- Impression test of 63Sn37Pb eutectic alloyMaterials Science and Engineering: A, 1995