To assess the effect of different peri- and intertubular dentin mineralization conditions and etching on shear bond strength in vitro. One hundred fifty crowns of extracted bovine incisors were embedded in resin and ground to expose the buccal coronal dentin. Sixty specimens were subjected to a demineralizing solution (DS) and another 60 teeth to a bacterial-based laboratory caries model (S. mutans, SM). Thirty specimens of each demineralization protocol (DS and SM) were randomly selected and remineralized (-R). Thirty sound dentin specimens served as control (C). Resin composite buildups (Tetric) were bonded after application of one of the following adhesives: a one-step self-etching adhesive (Xeno III), and a self-etching adhesive (Syntac Classic) without (three-step) and with prior additional 35% phosphoric acid etching (etch-and-rinse, four-step). Teeth were subjected to shear bond strength testing in a universal testing device at a crosshead speed of 0.5 mm/min (Ultradent method). Bond strength value for group C ranged from 6.3 to 8.4 MPa (p > 0.05). DS and DS-R samples showed in creased bond strength with the one-step adhesive (11.6 MPa, p < 0.05), whereas the three-step adhesive with additional etching showed decreased bond strength (3.2 MPa, p < 0.05). SM samples showed the lowest bond strength of all adhesive systems (range 1.1 to 1.5 MPa, p > 0.05). Remineralization showed no effect on the latter group. The degree of mineralization of the dentin is important for adhesion. Additional etching with phosphori acid reduced bond strength of a three-step adhesive.