Effect of Minute Bends and/or Kinks of Wire Bond Profile on Sag Deflection for 3-D and Multichip Module Semiconductor Packaging
Authors:
- 8 April 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Semiconductor Manufacturing
- Vol. 29 (2) , 168-175
Abstract
Wire sag and wire sweep developed during encapsulation process are counted for the lower yield rate of chip packaging in semiconductor industry. For conventional packaging, only one single layer of wire bond was constructed along the perimeter of chip system. The issue of wire sag is not a concern until 3-D and multi-chip modules packaging prevails due to the desperate demands of smaller and faster advanced microelectronics devices. Very few researches have been documented on this subject of sag deflection. An empirical equation based upon major profile parameters of a wire bond has been developed by author to predict sag deflection of ellipse shape wire bond. However, the effect of minute bends and/or kinks of wire bond profile on sag deflection has not been included. In this paper, we investigate three frequently used wire bond loops, Q loop, S loop, and M (modified) loop, to look into these minor characteristics of wire bond profile as compared to bond span and bond height. Based on current results, we find that these minute features may dominate the response of sag deflection of a wire bond.Keywords
Funding Information
- National Science Council of Taiwan through Cheng Shiu University (NSC101-2221-E- 230-003)
This publication has 9 references indexed in Scilit:
- The wire sag problem in wire bonding technology for semiconductor packagingMicroelectronics Reliability, 2013
- Empirical Equation of Wire Sag Model for Semiconductor Packaging With Numerical and Experimental VerificationIEEE Transactions on Components, Packaging and Manufacturing Technology, 2012
- Modeling and Experimental Study of the Kink Formation Process in Wire BondingIEEE Transactions on Semiconductor Manufacturing, 2012
- Fine and ultra‐fine pitch wire bonding: challenges and solutionsMicroelectronics International, 2009
- A method to determine the sweep resistance of wire bonds for microelectronic packagingMicroelectronic Engineering, 2008
- Evaluation of sweep resistance of Q Auto-Loop and Square-Loop bonds for semiconductor packaging technologyMicroelectronics Reliability, 2007
- Bondability, moldability, and reliability of very-long, multi-height Au bonding wires2006
- Study of wire bonding looping formation in the electronic packaging process using the three-dimensional finite element methodFinite Elements in Analysis and Design, 2004
- Wirebond profiles characterized by a modified linkage-spring model which includes a looping speed factorMicroelectronics Reliability, 2002