Tribology in Cold Metal Forming
Author:
- 1 November 1997
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 119 (4B) , 695-698
Abstract
The tribological aspects of cold metal forming processes is reviewed. Special attention is paid to rolling and stamping operations as these are typical of bulk forming and sheet forming processes, respectively, and are the most important commercial processes. It is shown that a better understanding of tribological fundamentals, as applied to cold metal forming, can result in better lubrication systems and process models.Keywords
This publication has 15 references indexed in Scilit:
- Low Speed Mixed Lubrication of Bulk Metal Forming ProcessesJournal of Tribology, 1996
- Lubrication of Aluminum Rolling by Oil-in-Water EmulsionsTribology Transactions, 1995
- Mixed Lubrication of Strip RollingTribology Transactions, 1994
- Lubrication With Binary Mixtures: Liquid-Liquid Emulsion in an EHL ConjunctionJournal of Tribology, 1993
- Surface asperity deformation during sheet formingInternational Journal of Mechanical Sciences, 1992
- Lubricating Properties of Oil-In-Water EmulsionsTribology Transactions, 1989
- Hydrodynamic lubrication in hemispherical punch stretch forming—Modified theory and experimental validationInternational Journal of Mechanical Sciences, 1987
- Tribology in Metalworking: Friction, Lubrication, and WearJournal of Applied Metalworking, 1984
- An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic LubricationJournal of Lubrication Technology, 1978
- Determination of Oil Film Thickness in Rolling from the Relationship between Surface Roughness of Strip and Roll : Investigation into Friction and Lubrication in Cold RollingBulletin of JSME, 1978