Study of die break strength and heat-affected zone for laser processing of thin silicon wafers
Authors:
Open Access
- 13 April 2015
- journal article
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 27 (3)
Abstract
As semiconductor based devices are manufactured on ever thinner silicon substrates, the required associated die break strength has to increase commensurately to maintain pick yields. In this study, the influence of laser processing parameters on the die break strength in laser dicing of silicon oxide-coated silicon wafers and silicon-based memory devices is investigated experimentally using ultraviolet lasers spanning a wide range of pulse width, from 400 fs to 150 ns. It is found that the net fluence, an accumulated pulse energy per surface area, is a meaningful process metric for damage induced by heat-affect zone to compare lasers processes with a large variety of pulse widths, laser scan speed, average powers, and repetition rates. Optimized process conditions for both nanosecond and femtosecond pulse widths are identified for achieving the highest die break strength in the target devices. The dependence of heat-affected zone on pulse width and net fluence during nanosecond laser processing is further demonstrated using multiphysical simulations. Simulations suggest that the thickest heat-affected zone section during laser scribing is typically located at the boundary of the laser incident surface. Simulation results also show that for a given repetition rate the heat-affected zone becomes larger as the net fluence increases due to smaller interpulse separation, consistent with the experimental observation.Keywords
This publication has 14 references indexed in Scilit:
- Multiphysical Simulation of ns-Laser Ablation of Multi-material LED-structuresPhysics Procedia, 2014
- Multiphysical Simulation of Laser Material ProcessingPhysics Procedia, 2012
- Laser Processing and Chemistry2011
- Numerical Simulations - A Versatile Approach for Better Understanding Dynamics in Laser Material ProcessingPhysics Procedia, 2011
- Effect of Dicing Technique on the Fracture Strength of Si Dies With Emphasis on Multimodal Failure DistributionIEEE Transactions on Device and Materials Reliability, 2009
- Laser Dicing of Silicon:Comparison of Ablation Mechanisms with a Novel Technology of Thermally Induced StressJournal of Laser Micro/Nanoengineering, 2008
- Laser helical drilling of silicon wafers with ns to fs pulses: Scanning electron microscopy and transmission electron microscopy characterization of drilled through-holesJournal of Laser Applications, 2006
- Femtosecond versus nanosecond laser machining: comparison of induced stresses and structural changes in silicon wafersApplied Surface Science, 2005
- Analysis of thermal damage in bulk silicon with femtosecond laser micromachining2004
- Crack formation during laser cutting of siliconJournal of Applied Physics, 1991