Enhancing the Corrosion Resistance of High Manganese Steel Through Controlled Chromium Additions
Open Access
- 11 December 2025
- journal article
- Published by Springer Nature in International Journal of Metalcasting
- Vol. 20 (5) , 3529-3541
Abstract
This study investigates the effect of controlled chromium (Cr) additions on the microstructure, corrosion resistance, hardness, and wear behavior of high manganese steel containing approximately 11 wt.% Mn and 1.1 wt.% C. Samples were prepared by induction melting and subjected to solution annealing at 1100 °C, followed by water quenching. The material was thoroughly characterized using a range of techniques, such as X-ray diffraction (XRD), scanning electron microscopy (SEM), electrochemical corrosion analysis, hardness testing, and resistance evaluation. X-ray diffraction (XRD) analysis confirmed a fully austenitic single-phase structure in all samples, with no formation of martensite or cementite due to the stabilizing effect of high manganese and carbon content. Electrochemical testing in artificial saliva (AS) revealed that the sample containing 1 wt.% Cr exhibited the best corrosion resistance, attributed to the formation of a protective Cr 2 O 3 passive film. However, higher Cr content (1.4 wt.%) resulted in slightly reduced corrosion performance due to microstructural defects observed via scanning electron microscopy (SEM). Hardness measurements showed the highest value in the Cr-free sample due to the presence of a needle-like cementite network, while Cr addition led to spheroidized carbides within the austenite grains. Wear resistance followed a similar trend, with the 1.4% Cr sample demonstrating performance comparable to the Cr-free sample, owing to finely dispersed chromium-rich carbides. The results suggest that an optimal Cr addition of ~1 wt.% enhances corrosion resistance without significantly compromising mechanical performance. These findings support the development of advanced high manganese steels for structural and biomedical applications where a balance between mechanical integrity and corrosion resistance is required.Keywords
Funding Information
- Helwan University
This publication has 18 references indexed in Scilit:
- Effect of Different Heat Treatment Procedures on the Corrosion Behavior of High-Manganese Austenitic SteelsInternational Journal of Metalcasting, 2025
- Effect of Heat Treatment Temperature on the Microstructure, Wear and Friction of Ni–Nb–V Alloyed Manganese SteelInternational Journal of Metalcasting, 2024
- Evaluation of the Effect of Shallow Cryogenic Treatment on Tribological Properties and Microstructure of High Manganese SteelInternational Journal of Metalcasting, 2023
- Metallurgical and Crystallographic Analysis of Different Amounts of Deformation Applied to Hadfield SteelInternational Journal of Metalcasting, 2022
- The influence of aluminum on microstructure, mechanical properties and wear performance of Fe–14%Mn–1.05%C manganese steelJournal of Materials Research and Technology, 2021
- Effect of Chemical Composition and Heat Treatments on the Microstructure and Wear Behavior of Manganese SteelInternational Journal of Metalcasting, 2020
- Scanning Electron Microscopy and X-Ray Microanalysis2018
- The effects of grain refinement and deformation on corrosion resistance of passive film formed on the surface of 304 stainless steelsMaterials Research Bulletin, 2015
- Degradable metallic biomaterials: Design and development of Fe–Mn alloys for stentsJournal of Biomedical Materials Research Part A, 2009
- Mechanism of work hardening in Hadfield manganese steelMetallurgical Transactions A, 1981