Microstructures of Oxidized Primary Carbides on Superalloy Inconel 718
Authors:
- 1 December 2005
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 502, 249-256
Abstract
The oxidation behavior of carbides on Inconel 718 surface was investigated. Oxidation tests were performed at the temperature range of 300 to 650°C. Two types of carbide, NbC and TiC were detected, and the amount of NbC was significantly higher than that of TiC. The oxidation of NbC started at the carbide surface and the matrix interface, and propagated into the interior of the carbide and eruption subsequently occurred with increasing oxidation time. In case of TiC, the oxidation occurred at the outer surface of the carbide and the matrix interface, but did not propagated into the interior of the carbide. Oxides formed on the outer surface of the TiC contained a relatively large amount of elemental Nb. The cross-section of oxidized specimen was investigated. NbC was oxidized more easily due to the significantly lower Gibbs free energy of oxidation than that of TiC. Eruption occurred mainly at the NbC because the Pilling-Bedworth ratio of Nb is higher than the critical value of 2.3 where eruption typically occurs.Keywords
This publication has 12 references indexed in Scilit:
- Modelling the optimum grain size on the low cycle fatigue life of a Ni based superalloy in the presence of two possible crack initiation sitesScripta Materialia, 2004
- Short crack initiation and growth at 600°C in notched specimens of Inconel718Materials Science and Engineering: A, 2003
- Electron Metallography of Alloy 7181997
- A kinetic study on oxidation of niobium carbideSolid State Ionics, 1993
- ELEVATED TEMPERATURE FATIGUE CRACK GROWTH IN ALLOY 718—PART I: EFFECTS OF MECHANICAL VARIABLESFatigue & Fracture of Engineering Materials & Structures, 1993
- Effect of environment on fatigue crack propagation behavior of alloy 718 at elevated temperaturesMetallurgical Transactions A, 1986
- The effect of grain size upon the fatigue-crack propagation behavior of alloy 718 under hold-time cycling at elevated temperatureEngineering Fracture Mechanics, 1986
- The effect of microstructure and environment on the crack growth behaviour of Inconel 718 alloy at 650 °C under fatigue, creep and combined loadingMaterials Science and Engineering, 1982
- AN INVESTIGATION OF THE CREEP‐FATIGUE‐ENVIRONMENT INTERACTION IN A Ni‐BASE SUPERALLOYFatigue & Fracture of Engineering Materials & Structures, 1979
- Frequency and wave-form effects on the fatigue crack growth behavior of alloy 718 at 298 K and 823 KMetallurgical Transactions A, 1978