Increasing the IDDQ test resolution using current prediction
Author:
- P.N. VariyamPVP.N. Variyam
- 8 November 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 217-224
Abstract
The Variations in IDDQ due to process disturbances forsub-micron ICs is comparable to magnitude of defectinduced currents. This is making traditional IDDQ testingineffective in detecting defects in sub-micron ICs. Thispaper presents a methodology called current predictionfor enhancing the effectiveness of IDDQ testing. In theproposed methodology, a set of IDDQ measurements areperformed on the device and the value of each IDDQcurrent are predicted using regression models. Absolutevalue of the difference between measured and predictedIDDQ (residuals of current prediction) are used foridentifying defective devices. The residuals of currentprediction are very sensitive to the defect currents and isinsensitive to process variations thus increasing the IDDQtest resolution. This technique is compared withtraditional and delta IDDQ testing techniques using theproduction test data from two different ICs. Results showthat considerable improvement in the IDDQ test qualitycan be achieved with the proposed technique.Keywords
This publication has 10 references indexed in Scilit:
- Current ratios: a self-scaling technique for production I/sub DDQ/ testing2003
- An histogram based procedure for current testing of active defects2003
- Failure analysis of timing and IDDq-only failures from the SEMATECH test methods experiment2003
- Iddq test: sensitivity analysis of scaling2002
- Current signatures for production testing [CMOS ICs]2002
- Current signatures [VLSI circuit testing]2002
- Intrinsic leakage in low power deep submicron CMOS ICs2002
- Current signatures: application2002
- Delta Iddq for testing reliability2002
- Possibilities and limitations of IDDQ testing in submicron CMOSIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part B, 1998