Theoretical and experimental analysis of a partially textured thrust bearing with square dimples
Authors:
- 1 July 2007
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
- Vol. 221 (7) , 771-778
Abstract
Surface texturing has proved to be very efficient in full and mixed lubrication, reducing the friction coefficient and the wear rate of mating surfaces. By partially texturing the inlet zone of a thrust washer pad load carrying capacity is generated in the system. In the present paper, a partially textured thrust bearing with square dimples is analysed theoretically using a thermohydrodynamic model. The equations are solved numerically by the finite-difference method. The bearing was realized by the photolithographic method and the theoretical results (fluid film thickness and friction torque) were compared with the experimental data obtained on the test rig. It is found that an optimal number of 12 sectors maximize the load carrying capacity of the bearing. The optimal textured fraction, which maximizes the load carrying capacity is 0.5 on the circumferential direction and 0.9-1 on the radial direction. A good correlation was found between the theoretical and experimental results for the two measured parameters (fluid film thickness and friction torque).Keywords
This publication has 15 references indexed in Scilit:
- Experimental Investigation of Partial Laser Surface Texturing for Piston-Ring Friction ReductionTribology Transactions, 2005
- Improving Tribological Performance of Piston Rings by Partial Surface TexturingJournal of Tribology, 2005
- The effect of laser surface texturing on transitions in lubrication regimes during unidirectional sliding contactTribology International, 2005
- Two-Dimensional CFD-Analysis of Micro-Patterned Surfaces in Hydrodynamic LubricationJournal of Tribology, 2005
- Effect of Deterministic Asperity Geometry on Hydrodynamic LubricationJournal of Tribology, 2004
- Influence of surface texture on boundary lubricated sliding contactsTribology International, 2003
- Loads carrying capacity map for the surface texture design of SiC thrust bearing sliding in waterTribology International, 2003
- Effect of surface texturing on friction reduction between ceramic and steel materials under lubricated sliding contactWear, 2003
- A Laser Surface Textured Parallel Thrust BearingTribology Transactions, 2003
- A Laser Surface Textured Hydrostatic Mechanical SealTribology Transactions, 2002