Significance of suction and dual stretching on the dynamics of various hybrid nanofluids: Comparative analysis between type I and type II models
- 17 August 2020
- journal article
- research article
- Published by IOP Publishing in Physica Scripta
- Vol. 95 (9) , 095205
Abstract
The transport phenomenon involving a thorough mixture of a base fluid and any two different types of nanoparticles (i.e. hybrid nanofluid) has attracted the attention of scientists to deliberate on the significance and performance of such fluid using two different types of thermo-physical models (i.e. type I and type II). This study examines the dynamics of hybrid nanofluids using type I and type II hybrid models with major emphasis on the difference. Also, this report unravels the significance of suction and dual stretching on the boundary layer flow of hybrid nanofluids. The governing equation that model the dynamics was modeled, non-dimenzionalized, parameterized, and solved numerically. It is concluded that both type I and type II models of viscosity should not be used for volume fraction ϕ 1 + ϕ 2 > 0.02 as both models are found to be the same, accurate but limited. The stretching ratio has dual effects on the velocity in both horizontal directions and temperature distribution decreases with stretching rate. Local skin friction coefficients and temperature distribution are decreasing properties of suction. In the case of various water-based conveying various nanoparticles (seven different hybrid nanofluids), optimal Nusselt number is ascertained at a larger value of stretching ratio and suction in the dynamics of water conveying (less dense nanoparticles) multiple wall CNT and silicon dioxide.Keywords
This publication has 68 references indexed in Scilit:
- Numerical investigation on effect of base fluids and hybrid nanofluid in forced convective heat transferInternational Journal of Thermal Sciences, 2013
- Effect of Al2O3–Cu/water hybrid nanofluid in heat transferExperimental Thermal and Fluid Science, 2012
- Synthesis of Al2O3–Cu/water hybrid nanofluids using two step method and its thermo physical propertiesColloids and Surfaces A: Physicochemical and Engineering Aspects, 2011
- Preparation and properties of hybrid water-based suspension of Al2O3 nanoparticles and MEPCM particles as functional forced convection fluidInternational Communications in Heat and Mass Transfer, 2010
- A benchmark study on the thermal conductivity of nanofluidsJournal of Applied Physics, 2009
- Role of Surface/Interfacial Cu2+ Sites in the Photocatalytic Activity of Coupled CuO−TiO2 NanocompositesThe Journal of Physical Chemistry C, 2008
- Conceptions for heat transfer correlation of nanofluidsInternational Journal of Heat and Mass Transfer, 2000
- HYDRODYNAMIC AND HEAT TRANSFER STUDY OF DISPERSED FLUIDS WITH SUBMICRON METALLIC OXIDE PARTICLESExperimental Heat Transfer, 1998
- Boundary‐layer behavior on continuous solid surfaces: II. The boundary layer on a continuous flat surfaceAIChE Journal, 1961
- The Viscosity of Concentrated Suspensions and SolutionsThe Journal of Chemical Physics, 1952