A topology of the multi-port DC circuit breaker for multi-terminal DC system fault protection
Authors:
- 1 October 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 3760-3763
Abstract
Hybrid DC circuit breaker, a combination of disconnector and multiple power electronic devices, has gained popularity for its low-loss at normal operation and its quick and effective circuit breaking during fault protection. However, its bulkiness threatens to limit its application in multi-terminal DC system, where the terminal is usually connected to more than one transmission lines and hence the circuit breaker tends to appear in clusters. In this context, a multi-port DC circuit breaker topology is proposed here. The circuit breakers at one terminal is integrated into one. Through this, it is able to cut down by half the number of power electronic devices needed, greatly reducing the size and cost for circuit breaking. The effectiveness of the proposed topology is verified by simulation results.Keywords
This publication has 8 references indexed in Scilit:
- Mitigation on requirement of DCCB by DC reactor for multi-terminal HVDC operation2016
- DC Circuit Breaker Requirements in Multi-Terminal HVDC Systems2016
- Identification and Small-Signal Analysis of Interaction Modes in VSC MTDC SystemsIEEE Transactions on Power Delivery, 2015
- Technical Assessment of Load Commutation Switch in Hybrid HVDC BreakerIEEE Transactions on Power Electronics, 2014
- A protection strategy for fault detection and location for multi-terminal MVDC distribution systems with renewable energy systems2014
- A Survey on Hybrid Circuit-Breaker TopologiesIEEE Transactions on Power Delivery, 2014
- The voltage sharing of commercial IGBTS in series with passive components2011
- Development of a 500kV Airblast HVDC Circuit BreakerIEEE Power Engineering Review, 1985