Identification and Protection of Series DC Arc Fault for Photovoltaic Systems Based on Fast Fourier Transform
Authors:
- 1 September 2019
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 159-163
Abstract
Nowadays, the development of renewable energy is increasing by many countries in the world, one of which is through the use of photovoltaic. By installing photovoltaic as a source of electrical energy, it is necessary to pay attention to the risks of hazards that arise, one of which is the series DC arc fault. Series DC arc fault cannot be detected by conventional safety device such as Circuit Breaker (CB), so special device is needed for photovoltaic systems, which can detect series DC arc fault and secure photovoltaic system by deciding current flow from photovoltaic to load when a series DC arc fault occur. Therefore, a series DC arc fault identification and protection device is designed, by utilizing a microcontroller and using the Fast Fourier Transform method to detect the presence of high frequency components at DC currents when a series DC arc fault occur, where the sum of high frequency components can be used as an algorithm for determining the series DC arc fault. The result shows that when the series DC arc fault occur, the current in the system decreases with a percentage decrease of 19.95% on average, and the sum of the spectrum values in the frequency range 0 to 12.5 kHz above 600. In securing the system, the device can works well, with the disconnection time of each test below the maximum allowed time in the UL 1699B, and has an average disconnection time of 0.67 seconds.Keywords
This publication has 9 references indexed in Scilit:
- Implementation AC Series Arc Fault Recognition using Mikrokontroller Based on Fast Fourier Transform2018
- Identification of harmonic loads using fast fourier transform and radial basis Function Neural Network2017
- Review and recent developments in DC arc fault detection2016
- The Detection of Series Arc Fault in Photovoltaic Systems Based on the Arc Current EntropyIEEE Transactions on Power Electronics, 2015
- Arc fault signal detection - Fourier transformation vs. wavelet decomposition techniques using synthesized data2014
- The characteristics of DC arc faults current2013
- The detection of DC arc fault: Experimental study and fault recognition2012
- Development of Arc-Fault Circuit-Interrupter requirements for Photovoltaic systems2011
- Design and analysis of aerospace DC arcing faults using fast fourier transformation and artificial neural network2004