EXPERIMENTAL INVESTIGATION OF TWO-PHASE HEAT TRANSFER OVER PARTIALLY ROUGHED VERTICAL TUBE
- 1 January 2025
- journal article
- Published by Begell House Inc. Publishers in Journal of Enhanced Heat Transfer
- Vol. 32 (3) , 1-17
Abstract
Saturated pool boiling over vertical tubes occurs in various industries, particularly the nuclear industry, as passive residual heat removal systems, where nucleate pool boiling plays a crucial role in transferring heat. The enhanced heat transfer of this equipment is challenging, however, and thus passive enhancement is prevalent in this field. Enhancement through the use of rough tubes (i.e., tubes with a textured or uneven surface) is a well-established, proven technique. However, rough tubes have some drawbacks in terms of promoting corrosion. Thus, this study aimed to introduce a new technique to enhance the thermal performance of existing conventional tubes. The present experiment introduced two partially rough vertical tubes: tubes with only the lower part rough (LPR) and tubes with only the upper part rough (UPR). The performance of these two versions was compared with that of a fully smooth tube and a fully rough (FR) tube. All test tubes were composed of AISI 304 grade stainless steel. Smoothness and roughness were achieved through turning with different grades of grit paper. It was found that the LPR, FR, and UPR tubes exhibit enhancements in nucleate boiling heat transfer coefficient of approximately 37%, 25%, and 9%, respectively, compared with a smooth tube at the highest heat flux of 72.92 kW/m2. Compared with the FR tube, the LPR tube exhibited 5% to 10% enhanced performance. This study highlights the single bubble trajectory over these vertical tubes to explore the physics behind the enhancement.Keywords
This publication has 33 references indexed in Scilit:
- Effect of surface roughness on contact resistance and electrochemical corrosion behavior of 446 stainless steel in simulated anode environments for proton exchange membrane fuel cellJournal of Solid State Electrochemistry, 2024
- A review on tube external heat transfer for passive residual heat removal heat exchanger in nuclear power plantApplied Thermal Engineering, 2019
- Experimental investigations on pool boiling on a vertical tube in the confined and unconfined spacesApplied Thermal Engineering, 2018
- A review on saturated boiling of liquids on tube bundlesHeat and Mass Transfer, 2013
- Research on the designed emergency passive residual heat removal system during the station blackout scenario for CPR1000Annals of Nuclear Energy, 2012
- Fouling of roughened stainless steel surfaces during convective heat transfer to aqueous solutionsEnergy Conversion and Management, 2008
- Steam generators – horizontal or vertical (which type should be used in nuclear power plants with VVER?)Atomic Energy, 2008
- Effects of heat exchanger tube geometries on nucleate pool boiling heat transfer in a scaled in-containment refueling water storage tankInternational Communications in Heat and Mass Transfer, 1996
- Experimental investigation of pool boiling of lithium bromide solution on a vertical tube under subatmospheric pressuresInternational Communications in Heat and Mass Transfer, 1991
- Evaporative heat transfer, pressure drop and critical heat flux in a small vertical tube with R-113International Journal of Heat and Mass Transfer, 1982