Low Firing Temperatures and High Ferroelectric Properties of (Ba0.85Ca0.15)(Ti0.90Zr0.10)O3Lead-Free Ceramics Synthesized by the Combustion Technique
- 26 January 2016
- journal article
- research article
- Published by Taylor & Francis in Ferroelectrics
- Vol. 491 (1) , 44-53
Abstract
This work studied the effect of firing conditions on phase formation, microstructure and electrical properties of (Ba0.85Ca0.15)(Ti0.90Zr0.10)O3;(abbreviated as BCTZ) ceramics, which were synthesized through the combustion technique. To reduce the reaction temperature, glycine was used as fuel with a ratio of raw material: glycine (1:1.11). BCTZ samples were calcined at 900–1200°C for 2 h and sintered at 1350 –1550°C for 2 h. Ultrafine BCTZ powder and single peroveskite phase were achieved from the sample calcined at 1050°C for 2 h.These results were obtained at a lower temperature and with shorter dwell time than those obtained using the solid state reaction method by ∼150°C and 1 h, respectively. The BCTZ ceramics exhibited a coexistence of rhombohedral and orthorhombic phase in all samples. The average particle size and the average grain size increased from 172 to 295 nm and 0.82 to 2.57 µm, respectively, when firing temperatures increased. The highest density (5.76 g/cm3), highest dielectric constant (ϵr ≅ 4485 and ϵmax ≅ 14897) and best ferroelectric properties (Pr ≅ 18.47 μC/cm2 and EC ≅ 4.52 kV/cm) were obtained from the sample sintered at 1450°C for 2 h.Keywords
This publication has 20 references indexed in Scilit:
- High piezoelectric coefficient of Pr2O3-doped Ba0.85Ca0.15Ti0.90Zr0.10O3 ceramicsCeramics International, 2012
- Composition and poling condition-induced electrical behavior of (Ba0.85Ca0.15)(Ti1−xZrx)O3 lead-free piezoelectric ceramicsJournal of the European Ceramic Society, 2012
- Effect of dwell time during sintering on piezoelectric properties of (Ba0.85Ca0.15)(Ti0.90Zr0.10)O3 lead-free ceramicsJournal of Alloys and Compounds, 2011
- Enhanced piezoelectric properties of (Ba0.85Ca0.15)(Ti0.9Zr0.1)O3 lead-free ceramics by optimizing calcination and sintering temperatureJournal of the European Ceramic Society, 2011
- Optimum Sintering Temperature for Fabrication of 0.8Bi0.5Na0.5TiO3-0.2Bi0.5K0.5TiO3 Lead-Free Ceramics by Combustion TechniqueKey Engineering Materials, 2011
- Fabrication of (Ba1−xSrx)(ZrxTi1−x)O3ceramics prepared using the combustion techniqueSmart Materials and Structures, 2010
- Large Piezoelectric Effect in Pb-Free CeramicsPhysical Review Letters, 2009
- Phase formation and electrical properties of BNLT–BZT lead-free piezoelectric ceramic systemCurrent Applied Physics, 2009
- Piezoelectric properties of Li- and Ta-modified (K0.5Na0.5)NbO3 ceramicsApplied Physics Letters, 2005
- Lead-free piezoceramicsNature, 2004