Basalt fiber reinforced polypropylene to manufacture 3D printed composites
Open Access
- 2 June 2024
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 45 (13) , 12362-12376
Abstract
Polypropylene (PP) is one of the most used polymeric materials worldwide, either as a neat material or as a matrix for composite manufacture employing a molding process. Fused deposition modeling (FDM) 3D printing is an alternative process that offers the potential for manufacturing value‐added products from PP. However, using neat PP for FDM is challenging because 3D‐printed PP warps and shrinks when cooled, and the mechanical properties of PP are poor. PP‐based composites with different fillers (e.g., glass, carbon, and natural fibers) have shown improved properties using FDM processes. An alternative filler for 3D‐printed PP‐based composites is basalt fiber (BF). The objective of this work was to assess the potential and impacts of BF as a filler for BF‐PP composites using FDM processes. PP was compounded with 15, 25, 35, and 45 wt% BF to produce filaments for 3D printing without adding any compatibilizer. Results of rheology studies, morphology, and mechanical and thermal properties of the 3D printed specimens showed that BF positively impacts Young's modulus (E), thermal stability, and dimensional stability of the composite. All composites, when processed at high shear rates (i.e., above 100 1/s), show approximately similar rheological behavior. E is almost doubled in the composite with 25 wt% BF and increased fourfold in the composite with 35 and 45 wt% BF, compared to neat PP. The Izod impact resistance of the formulations containing 35 and 45 wt% BF is ~70% that of neat PP. BF process easily and adequately reinforces PP composites manufactured via FDM.Highlights: Neat PP's poor mechanical properties are improved by adding basalt fiber (BF). Up to 45 wt% BF was used to reinforce PP‐based composites. PP‐BF composites are easier to process via DFM compared to neat PP. BF improves PP‐based composite's thermal and dimensional stability.Keywords
Funding Information
- National Science Foundation (1738669)
This publication has 46 references indexed in Scilit:
- Development and erosion wear analysis of polypropylene/Linz‐Donawitz sludge compositesPolymer Composites, 2023
- How open‐stage melt crystallization affects tensile and shrinkage properties of 3D printed polypropylenePolymer Engineering & Science, 2023
- Influence of material modification and fillers on the dimensional stability and warpage of polypropylene in screw‐extrusion‐based large area additive manufacturingPolymer Engineering & Science, 2023
- Designing 3D printable polypropylene: Material and process optimisation through rheologyAdditive Manufacturing, 2021
- Material extrusion‐based additive manufacturing of polypropylene: A review on how to improve dimensional inaccuracy and warpageJournal of Applied Polymer Science, 2019
- Interlayer fracture toughness of additively manufactured unreinforced and carbon-fiber-reinforced acrylonitrile butadiene styreneAdditive Manufacturing, 2018
- Injection molding of polypropylene hybrid composites reinforced with carbon fiber and wood fiberPolymer Composites, 2017
- Polyolefins in Automotive Industry2015
- Wood plastic composites from agro-waste materials: Analysis of mechanical propertiesBioresource Technology, 2010
- Optimising industrial hemp fibre for compositesComposites Part A: Applied Science and Manufacturing, 2007