Prediction and Analysis of EMI Spectrum Based on the Operating Principle of EMC Spectrum Analyzers
- 2 May 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (1) , 263-275
Abstract
EMC spectrum analyzers are popularly used for electromagnetic interference (EMI) measurement in power electronics systems. Depending on the specifications of EMI standards, the EMI measurement could be very time-consuming. Conventionally, the fast Fourier transform (FFT) is used to derive the EMI spectrum from the measured time domain waveforms. However, these results may not agree with the measurement results from spectrum analyzers, and sometimes the difference could be significant. In this paper, a technique to quickly and accurately predict and analyze the EMI spectrum from time-domain waveforms is proposed. The technique is developed based on the spectrum analyzer's operating principle and the requirements of EMI standards. The EMI spectra of three modulation schemes are also analyzed. Theoretical analysis, simulations and experiments were all conducted. The predicted peak, quasi-peak and average EMI matches the measured EMI in whole conductive frequency range. The developed technique can accurately predict EMI using much shorter time than conventional EMC spectrum analyzers and it saves cost of expensive spectrum analyzers.Keywords
Funding Information
- CRRC Zhuzhou Institute Co., Ltd.
This publication has 20 references indexed in Scilit:
- Common-Mode EMI Noise Modeling and Reduction With Balance Technique for Three-Level Neutral Point Clamped TopologyIEEE Transactions on Industrial Electronics, 2017
- EMI Reduction via Spread Spectrum in DC/DC Converters: State of the Art, Optimization, and TradeoffsIEEE Access, 2015
- EMI-receiver simulation model with quasi-peak detector2015
- The Worst Conducted EMI Spectrum of Critical Conduction Mode Boost PFC ConverterIEEE Transactions on Power Electronics, 2014
- DM EMI Noise Prediction for Constant On-Time, Critical Mode Power Factor Correction ConvertersIEEE Transactions on Power Electronics, 2012
- Design Guidelines for Interleaved Single-Phase Boost PFC CircuitsIEEE Transactions on Industrial Electronics, 2009
- Reduced Conductive EMI in Switched-Mode DC–DC Power Converters Without EMI Filters: PWM Versus Randomized PWMIEEE Transactions on Power Electronics, 2006
- Differential Mode Input Filter Design for a Three-Phase Buck-Type PWM Rectifier Based on Modeling of the EMC Test ReceiverIEEE Transactions on Industrial Electronics, 2006
- Characterization, Evaluation, and Design of Noise Separator for Conducted EMI Noise DiagnosisIEEE Transactions on Power Electronics, 2005
- Reduction of power supply EMI emission by switching frequency modulationIEEE Transactions on Power Electronics, 1994