Effect of Thermomechanical Processing on Porosity Evolution and Mechanical Properties of L-PBF AISI 316L Stainless Steel
Open Access
Abstract
Thermomechanical processing has a significant impact on the porosity and mechanical properties of AISI 316L stainless steel produced by laser powder bed fusion (L-PBF). This work evaluated the effect of three heat treatment conditions: as-built (HT0), annealed at 650 °C for 3 h with air cooling (HT1), and annealed at 1050 °C for 1 h followed by water quenching (HT2), combined with cold and hot rolling at different strain levels. The most pronounced improvement was observed after 20% hot rolling followed by water quenching (HR + WQ), which reduced porosity to 0.05% and yielded the most spherical pores, with a circularity factor () of 0.90 and an aspect ratio (AsR) of 1.57. At elevated temperatures, the matrix becomes more pliable, which promotes pore closure and helps reduce stress concentrations. On the other hand, applying heat treatment without causing deformation resulted in the pores growing and increasing porosity in the build direction. The fractography supported these findings, showing a transition from brittle to more ductile fracture surfaces. Heat treatment combined with plastic deformation effectively reduced internal defects and improved both structural integrity and strength.
Keywords
Funding Information
- NextGenerationEU through the Recovery and Resilience Plan for Slovakia (09I03-03-V04-00049)
This publication has 67 references indexed in Scilit:
- The effect of energy density and porosity structure on tensile properties of 316L stainless steel produced by laser powder bed fusionProgress in Additive Manufacturing, 2022
- A critical review on the effects of process-induced porosity on the mechanical properties of alloys fabricated by laser powder bed fusionJournal of Materials Science, 2022
- Additive manufacturing of steels: a review of achievements and challengesJournal of Materials Science, 2020
- Influence of heat treatment temperature on the microstructural, mechanical, and wear behavior of 316L stainless steel fabricated by laser powder bed additive manufacturingThe International Journal of Advanced Manufacturing Technology, 2020
- Microstructural porosity in additive manufacturing: The formation and detection of pores in metal parts fabricated by powder bed fusionJournal of Advanced Manufacturing and Processing, 2019
- Effect of heat treatments on pore morphology and microstructure of laser additive manufactured partsMaterial Design & Processing Communication, 2019
- On the deformation twinning mechanisms in twinning-induced plasticity steelActa Materialia, 2017
- Laser powder-bed fusion additive manufacturing: Physics of complex melt flow and formation mechanisms of pores, spatter, and denudation zonesActa Materialia, 2016
- Metal Additive Manufacturing: A ReviewJournal of Materials Engineering and Performance, 2014
- Effect of Heat Treatment on the Microstructure and Mechanical Properties of Stainless Steel 316L Coatings Produced by Cold Spray for Biomedical ApplicationsJournal of Thermal Spray Technology, 2014