Three-dimensional Volumetric Filling Ratio Predicts Stress Shielding in Short-stem Anatomic Total Shoulder Arthroplasty
Authors:
- Haluk CelikHCHaluk Celik
- Aakash ChauhanACAakash Chauhan
- Cesar Flores-HernandezCFCesar Flores-Hernandez
- Darryl D'LImaDDDarryl D'LIma
- Heinz HoeneckeHHHeinz Hoenecke
- 14 April 2020
- journal article
- research article
- Published by Wolters Kluwer Health in Journal of the American Academy of Orthopaedic Surgeons
- Vol. 28 (24) , 1047-1054
Abstract
Introduction: Three-dimensional (3-D) CT volumetric filling ratio (VFR) is a better predictor of proximal humerus stress shielding after short-stem anatomic total shoulder arthroplasty (aTSA) than using plain radiographs. Methods: Forty-four patients with short-stem aTSAs, preoperative CT scans, and a minimum 3-year radiographic follow-up were included. Patients were divided into group A (stress shielding) and group B (no stress shielding) based on the radiographic analysis. Standard implant filling ratios were measured on plain radiographs. The 3-D VFR of the metaphyseal and diaphyseal segments of the aTSA stem was measured using MIMICS (Materialise). The area under a receiver operator characteristic curve was used to determine the predictive strength of the 3-D VFR method. Results: The average age and radiographic follow-up was 69 years and 44 months. Group A had 19 patients and statistically higher filling ratios using 3-D VFR method than group B, whereas no notable differences were found between the groups using standard techniques. The 3-D VFR had an area under a receiver operator characteristic curve of 92%, which supports it as a good predictor of stress shielding. Conclusions: These methods enable early identification of patients at risk for stress shielding and can also be valuable in improving humeral stem designs. Level of Evidence: Level III. Case-control studyKeywords
This publication has 19 references indexed in Scilit:
- Radiographic evaluation of short-stem press-fit total shoulder arthroplasty: short-term follow-upJournal of Shoulder and Elbow Surgery, 2016
- Comparison of proximal humeral bone stresses between stemless, short stem, and standard stem length: a finite element analysisJournal of Shoulder and Elbow Surgery, 2016
- Radiologic bone adaptations on a cementless short-stem shoulder prosthesisJournal of Shoulder and Elbow Surgery, 2016
- Clinical and radiological results of a cementless short stem shoulder prosthesis at minimum follow-up of two yearsInternational Orthopaedics, 2015
- Patterns of proximal humeral bone resorption after total shoulder arthroplasty with an uncemented rectangular stemJournal of Shoulder and Elbow Surgery, 2014
- Radiographic Changes Around Humeral Components in Shoulder ArthroplastyJournal of Bone and Joint Surgery, 2014
- Long-term results of uncemented humeral components in shoulder arthroplastyJournal of Shoulder and Elbow Surgery, 2007
- A Comparison of Pain, Strength, Range of Motion, and Functional Outcomes After Hemiarthroplasty and Total Shoulder Arthroplasty in Patients with Osteoarthritis of the ShoulderJournal of Bone and Joint Surgery, 2005
- Total shoulder arthroplasty: Long-term survivorship, functional outcome, and quality of lifeJournal of Shoulder and Elbow Surgery, 2005
- Stress shielding and bone resorption in shoulder arthroplastyJournal of Shoulder and Elbow Surgery, 2003