Gas Atomization of Aluminium Melts: Comparison of Analytical Models
Open Access
Abstract
A number of analytical models predicting the size distribution of particles during atomization of Al-based alloys by N2, He and Ar gases were compared. Simulations of liquid break up in a close coupled atomizer revealed that the finer particles are located near the center of the spray cone. Increasing gas injection pressures led to an overall reduction of particle diameters and caused a migration of the larger powder particles towards the outer boundary of the flow. At sufficiently high gas pressures the spray became monodisperse. The models also indicated that there is a minimum achievable mean diameter for any melt/gas system.Keywords
This publication has 23 references indexed in Scilit:
- Simulation of liquid jet primary breakup: Dynamics of ligament and droplet formationInternational Journal of Multiphase Flow, 2010
- Secondary atomizationExperiments in Fluids, 2009
- Bag breakup of nonturbulent liquid jets in crossflowInternational Journal of Multiphase Flow, 2008
- Experimental study on atomization phenomena of kerosene in supersonic cold flowScience China Technological Sciences, 2008
- Mechanisms of free-surface breakup in vibration-induced liquid atomizationPhysics of Fluids, 2007
- Experimental analysis of liquid–gas interface at low Weber number: interface length and fractal dimensionExperiments in Fluids, 2005
- The effects of nozzle geometry on waterjet breakup at high Reynolds numbersExperiments in Fluids, 2003
- Experimental and theoretical effects of nitrogen gas flow rate on liquid-jet atomizationJournal of Propulsion and Power, 1988
- Effect of processing variables on particle size in gas atomization of rapidly solidified aluminium powdersMaterials Science and Technology, 1987
- Interactions between nitrogen jets and liquid lead and tin streamsPowder Technology, 1978