Synthesis and mechanical properties of unsaturated polyester based nanocomposites
Authors:
- 1 March 2003
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 43 (3) , 661-669
Abstract
Two classes of nanocomposites were synthesized using an unsaturated polyester resin as the matrix and sodium montmorillonite as well as an organically modified montmorillonite as the reinforcing agents. X‐ray diffraction pattern of the composites showed that the interlayer spacing of the modified montmorillonite expanded from 1.25 nm to 4.5 nm, indicating intercalation. Glass transition values of these composites increased from 72°C, in the unfilled unsaturated polyester, to 86°C in the composite with 10% organically modified montmorillonite. From Scanning Electron Microscopy, it is seen that the degree of intercalation/exfoliation of the modified montmorillonite is higher than in the unmodified one. The mechanical properties also supported these findings, since in general, the tensile modulus, tensile strength, flexural modulus, flexural strength and impact strength of the composites with modified montmorillonite were higher than the corresponding properties of the composites with unmodified montmorillonite. The tensile modulus, tensile strength, flexural modulus and flexural strength values showed a maximum, whereas the impact strength exhibited a minimum at approximately 3–5 wt% modified montmorillonite content. These results imply that the level of exfoliation may also exhibit a maximum with respect to the modified montmorillonite content. The level of improvement in the mechanical properties was substantial. Adding only 3 wt% organically modified clay improved the flexural modulus of unsaturated polyester by 35%. The tensile modulus of unsaturated polyester was also improved by 17% at 5 wt% of organically modified clay loading.Keywords
This publication has 9 references indexed in Scilit:
- Studies on thermal and mechanical properties of polyimide–clay nanocompositesPolymer, 2001
- Synthesis of epoxy–clay nanocomposites. Influence of the nature of the curing agent on structurePolymer, 2001
- Polymer–clay nanocomposites: exfoliation of organophilic montmorillonite nanolayers in polystyrenePolymer, 2001
- The effects of promoter and curing process on exfoliation behavior of epoxy/clay nanocompositesJournal of Applied Polymer Science, 2000
- Nanocomposites based on montmorillonite and unsaturated polyesterPolymer Engineering & Science, 1998
- Characterization of epoxy-clay hybrid composite prepared by emulsion polymerizationJournal of Applied Polymer Science, 1998
- Kinetics of Polymer Melt IntercalationMacromolecules, 1995
- Nylon 6–Clay HybridMRS Proceedings, 1989
- Mechanical behavior and dilatation of particulate‐filled thermosets in the glassy statePolymer Composites, 1983