Optimal Shape Selection of Heat Exchangers Surfaces during Convective Heat Transfer
Authors:
- 1 October 2018
- journal article
- Published by Trans Tech Publications, Ltd. in Solid State Phenomena
- Vol. 284, 1337-1341
Abstract
The article contains the results of a research in constructing of modern heat exchangers form of heat exchanging surfaces and modes of heat media flux, providing minimum area (size) of heat exchanging apparatus. Decreasing of heat-transferring area is achieved by using different techniques of intensification of convective heat exchange. Intensification of the heat exchange is accompanied by increasing of energy consumption for pumping the coolant. It is concluded that under the conditions of turbulent flow, the transport mechanism does not strongly depend on the shape of the perturbations introduced into the flow, while the tendency to approach the dependences is common to the curves for the considered surfaces, and the experimental data obtained on pipes with a periodic section of the flow cross-section along the length. Using surfaces creating channels with a greater coefficient of hydraulic resistance when creating a compact heat exchangers, which corresponds to surfaces for which the principle of trans-verse flow is realized.Keywords
This publication has 5 references indexed in Scilit:
- Numerical optimization of heat exchangers with circular and non-circular shapesCase Studies in Thermal Engineering, 2015
- Optimal Shape Design of Compact Heat Exchangers Based on Adjoint Analysis of Momentum and Heat TransferJournal of Thermal Science and Technology, 2010
- Numerical study of heat transfer and pressure drop for flow past inline and staggered tube bundlesInternational Journal of Numerical Methods for Heat & Fluid Flow, 2009
- Optimal Design of a Parallel-Flow Heat Exchanger Using a Response Surface MethodologyNumerical Heat Transfer, Part A: Applications, 2006
- Heat Transfer around Tubes in Staggered Tube BanksBulletin of JSME, 1982