The Importance of the Temperature and Lateral Pressure on the CFRP Joints Strength under Uniaxial Loading
Authors:
- Giuseppe MariniGMGiuseppe Marini
- 1 June 1997
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 16 (9) , 825-847
Abstract
The purpose of the present paper is to provide the assessment and evaluation results of the temperature and lateral pressure influence on the CFRP pin loaded joints strength while they are subjected to tension. The subject study is composed of the following two main parts: 1. the Experimental Results, which are obtained through the application of four (4) different lateral pressure conditions (none, low, medium, and high), and range of temperatures (room, + 60°C, + 80°C, -55°C, -100°C, and -150°C) 2. the Theoretical Results, which are obtained through the use of 2D finite element analysis In addition, the study provides an in depth description of the employed test methodology and a comparison of the numerical and experimental final results.Keywords
This publication has 19 references indexed in Scilit:
- Analytical solutions for load transfer through smooth elastic pin in an infinite orthotropic plateComposite Structures, 1995
- Thermomechanical generalization of pin joints in finite platesComputers & Structures, 1993
- On design methods for bolted joints in composite aircraft structuresComposite Structures, 1993
- Bolted joints in a laminated composite strut design expert systemComposite Structures, 1992
- On the Bearing Strength of Bolted Graphite/Epoxy LaminatesJournal of Composite Materials, 1990
- Stress and Failure Analysis of a Pin-Loaded Composite Plate: An Experimental StudyJournal of Composite Materials, 1990
- Recent studies on the behaviour of interference fit pins in composite platesComposite Structures, 1989
- Strength of Mechanically Fastened Composite JointsJournal of Composite Materials, 1982
- Stress distribution around a single bolt in fibre-reinforced plasticComposites, 1982
- Stresses Around Pin-Loaded Holes in Elastically Orthotropic or Isotropic PlatesJournal of Composite Materials, 1977