Assessment of a Two-Layer Material Point Method for Three-Dimensional Water-Granular Sloshing
Open Access
- 30 September 2026
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 16 (19) , 9743
Abstract
Molten-pool sloshing is a critical safety concern during Core Disruptive Accidents (CDAs) in Sodium-cooled Fast Reactors (SFRs), as the inward collapse of the liquid fuel may lead to energetic neutronic recriticality. The presence of solid particles further complicates the flow physics through interphase drag, particle wall friction, and granular yielding. This study assesses a two-layer Material Point Method (MPM) for three-dimensional water-granular sloshing using pure-water comparisons and four centered water-acrylic-particle configurations from the KfK 5090 experimental campaign. The two phases use superposed momentum grids with implicit drag coupling, APIC transfer for water, and ASFLIP transfer for the granular phase. Pure-water calculations examine regional pressure sensitivity and free-surface evolution in centered and offset geometries. Closure parameters are selected using the layered saturated case D1PI-1 and are subsequently held fixed for the fully mixed case D1PI-2 and the dry-annulus cases D1P-1 and D1P-2. In D1PI-1, the five reported standardized residuals have magnitudes no greater than 1.10 under the adopted normalization, although the ensemble-mean wall and center heights are overpredicted and the center rebound exhibits appreciable realization variability. The other configurations expose substantial discrepancies in wall run-up, supported water arrival, and, for the thicker dry annulus, center rebound. Coupled grid-sensitivity studies for D1PI-1 and D1P-1 show comparatively stable peak timing but appreciable sensitivity of rebound height, and the 4 mm grid is retained as an engineering baseline. These results document calibration performance and limited cross-configuration transferability, and motivate further investigation of transient momentum exchange, segregation, and wetting before application to severe-accident conditions.Keywords
This publication has 25 references indexed in Scilit:
- MPMICE: A hybrid MPM‐CFD model for simulating coupled problems in porous media. Application to earthquake‐induced submarine landslidesInternational Journal for Numerical Methods in Engineering, 2023
- Prediction of flow-regime characteristics in pool sloshing behavior with solid particlesAnnals of Nuclear Energy, 2018
- Fundamental validation of the finite volume particle method for 3D sloshing dynamicsInternational Journal for Numerical Methods in Fluids, 2010
- Modeling strategies for multiphase drag interactions using the material point methodInternational Journal for Numerical Methods in Engineering, 2010
- Drag force of intermediate Reynolds number flow past mono‐ and bidisperse arrays of spheresAIChE Journal, 2007
- Application of a particle-in-cell method to solid mechanicsComputer Physics Communications, 1995
- A particle method for history-dependent materialsComputer Methods in Applied Mechanics and Engineering, 1994
- A Level Set Approach for Computing Solutions to Incompressible Two-Phase FlowJournal of Computational Physics, 1994
- The voidage function for fluid-particle interaction systemsInternational Journal of Multiphase Flow, 1994
- Generalized friction factor and drag coefficient correlations for fluid-particle interactionsChemical Engineering Science, 1985