Matching Measurement Strategy and Form Error Compensation for Freeform Surface Machining Based on STS Turning
Open Access
- 31 May 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (11) , 5584
Abstract
The freeform surface quality is limited by the measurement, and form error cannot be convergent via compensation machining. This paper proposed a surface matching measurement strategy based on the least squares principle and iterative precision adjustment to precisely obtain surface form error after manufacturing by single point diamond turning. Through the coordinate transformation of translation and rotation, the measured surface was aligned with theoretical surface at the same coordinate system. The corresponding simulation was carried out to verify the performance of the proposed method, and the simulation results indicated that this method can achieve accurate alignment in a sub-nanometer range. Finally, with XY polynomial freeform surface as the ideal surface, compensation experiments were undertaken. The form error of freeform converged continuously after compensation machining for three times, during which the form accuracy of PV and RMS were down to 335 nm and 34 nm respectively from 1.4 um and 173 nm. The results showed that capability of the proposed compensation method was verified and the form accuracy could be improved effectively.Keywords
Funding Information
- Key Industry Innovation Chain Project of Shaanxi Provincial Science and the Technology Department (2021ZDLGY12-05, 20JK0675, JCKY2020426B009)
- Scientific Research Plan Projects of Shaanxi Education Department (2021ZDLGY12-05, 20JK0675, JCKY2020426B009)
- Basic Scientific Research (2021ZDLGY12-05, 20JK0675, JCKY2020426B009)
This publication has 20 references indexed in Scilit:
- Compensation strategy for machining optical freeform surfaces by the combined on- and off-machine measurementOptics Express, 2015
- Tool path generation for slow tool servo turning of complex optical surfacesThe International Journal of Advanced Manufacturing Technology, 2015
- 5-Axis adaptive flank milling of flexible thin-walled parts based on the on-machine measurementInternational Journal of Machine Tools and Manufacture, 2014
- A theoretical and experimental investigation of design and slow tool servo machining of freeform progressive addition lenses (PALs) for optometric applicationsThe International Journal of Advanced Manufacturing Technology, 2013
- Manufacturing and measurement of freeform opticsCIRP Annals, 2013
- Design, fabrication, and metrology of ultra-precision optical freeform surface for progressive addition lens with B-spline descriptionThe International Journal of Advanced Manufacturing Technology, 2012
- An integrated form characterization method for measuring ultra-precision freeform surfacesInternational Journal of Machine Tools and Manufacture, 2007
- Fabrication of diffractive optics by use of slow tool servo diamond turning processOptical Engineering, 2006
- A practical evaluation approach towards form deviation for two-dimensional contours based on coordinate measurement dataInternational Journal of Machine Tools and Manufacture, 2000
- Fitting Measured Points to a Parametric Surface.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 1997