Detecting cm-scale hot spot over 24-km-long single-mode fiber by using differential pulse pair BOTDA based on double-peak spectrum
Open Access
- 14 July 2017
- journal article
- research article
- Published by Optica Publishing Group in Optics Express
- Vol. 25 (15) , 17727-17736
Abstract
In distributed Brillouin optical fiber sensor when the length of the perturbation to be detected is much smaller than the spatial resolution that is defined by the pulse width, the measured Brillouin gain spectrum (BGS) experiences two or multiple peaks. In this work, we propose and demonstrate a technique using differential pulse pair Brillouin optical time-domain analysis (DPP-BOTDA) based on double-peak BGS to enhance small-scale events detection capability, where two types of single mode fiber (main fiber and secondary fiber) with 116 MHz Brillouin frequency shift (BFS) difference have been used. We have realized detection of a 5-cm hot spot at the far end of 24-km single mode fiber by employing a 50-cm spatial resolution DPP-BOTDA with only 1GS/s sampling rate (corresponding to 10 cm/point). The BFS at the far end of 24-km sensing fiber has been measured with 0.54 MHz standard deviation which corresponds to a 0.5°C temperature accuracy. This technique is simple and cost effective because it is implemented using the similar experimental setup of the standard BOTDA, however, it should be noted that the consecutive small-scale events have to be separated by a minimum length corresponding to the spatial resolution defined by the pulse width difference.Keywords
Funding Information
- National Key Scientific Instrument and Equipment Development Project of China (2013YQ040815, 2017YFF0108700)
- National Natural Science Foundation of China (NSFC) (61575052,61308004)
This publication has 18 references indexed in Scilit:
- Ultrahigh-speed distributed Brillouin reflectometryLight: Science & Applications, 2016
- Going beyond 1000000 resolved points in a Brillouin distributed fiber sensor: theoretical analysis and experimental demonstrationLight: Science & Applications, 2016
- Extending the Sensing Range of Brillouin Optical Time-Domain Analysis Combining Frequency-Division Multiplexing and In-Line EDFAsJournal of Lightwave Technology, 2011
- Differential Brillouin gain for improving the temperature accuracy and spatial resolution in a long-distance distributed fiber sensorApplied Optics, 2009
- Differential pulse-width pair BOTDA for high spatial resolution sensingOptics Express, 2008
- Distributed Brillouin fiber sensor for detecting pipeline buckling in an energy pipe under internal pressureApplied Optics, 2006
- Coherent probe-pump-based Brillouin sensor for centimeter-crack detectionOptics Letters, 2005
- Trade-off between the spatial and the frequency resolutions in measuring the power spectrum of the Brillouin backscattered light in an optical fiberApplied Optics, 1999
- Characterization of the Brillouin-loss spectrum of single-mode fibers by use of very short (<10-ns) pulsesOptics Letters, 1999
- 6.6 kV XLPE submarine cable with optical fiber sensors to detect anchor damage and defacement of wire armorIEEE Transactions on Power Delivery, 1995