Research on modeling of heat source for electron beam welding fusion-solidification zone
Authors:
- Pengfei FuPFPengfei Fu
- Yongjun GuanYGYongjun Guan
- Zhijun LuZLZhijun Lu
- Yintao WeiYWYintao Wei
Open Access
- 1 February 2013
- journal article
- Published by Elsevier in Chinese Journal of Aeronautics
- Vol. 26 (1) , 217-223
Abstract
No abstract availableKeywords
This publication has 9 references indexed in Scilit:
- Modelling of Seebeck effect in electron beam deep welding of dissimilar metalsCOMPEL - The international journal for computation and mathematics in electrical and electronic engineering, 2009
- Heat transfer and fluid flow during electron beam welding of 21Cr–6Ni–9Mn steel and Ti–6Al–4V alloyJournal of Physics D: Applied Physics, 2008
- Analytical solution for three-dimensional model predicting temperature in the welding cavity of electron beamVacuum, 2007
- Estimation of a source term in a two-dimensional heat transfer problem: application to an electron beam weldingInverse Problems in Science and Engineering, 2006
- Design of Electrostatic Focusing for Space Electron Beam Welding GunChinese Journal of Aeronautics, 2005
- Investigation of electron-beam welding in wrought Inconel 706—experimental and numerical analysisMaterials Science and Engineering: A, 2005
- Nickel based superalloy welding practices for industrial gas turbine applicationsScience and Technology of Welding and Joining, 2004
- A point and line source model of laser keyhole weldingJournal of Physics D: Applied Physics, 1988
- Calculations of the form of the penetration zone in laser welding using a model of two heat sourcesWelding International, 1987