Computational Studies of Air-Mist Spray Cooling in Continuous Casting
Open Access
Abstract
Due to the significant reduction in water droplet size caused by the strong air-water interaction in the spray nozzle, air-mist spray is one of the promising technologies for achieving high-rate heat transfer. This study numerically analyzed air-mist spray produced by a flat-fan atomizer using three-dimensional computational fluid dynamics simulations, and a multivariable linear regression was used to develop a correlation to predict the heat transfer coefficient using the casting operating conditions such as air-pressure, water flow rate, casting speed, and standoff distance. A four-step simulation approach was used to simulate the air-mist spray cooling capturing the turbulence and mixing of the two fluids in the nozzle, droplet formation, droplet transport and impingement heat transfer. Validations were made on the droplet size and on the VOF-DPM model which were in good agreement with experimental results. A 33% increase in air pressure increases the lumped HTC by 3.09 ± 2.07% depending on the other casting parameters while an 85% increase in water flow rate reduces the lumped HTC by 4.61 ± 2.57%. For casting speed, a 6.5% decrease in casting speed results in a 1.78 ± 1.42% increase in the lumped HTC. The results from this study would provide useful information in the continuous casting operations and optimization.Keywords
This publication has 74 references indexed in Scilit:
- Boiling curves in relation to quenching of a high temperature moving surface with liquid jet impingementInternational Journal of Heat and Mass Transfer, 2009
- Theoretical and experimental study of the effects of spray inclination on two-phase spray cooling and critical heat fluxInternational Journal of Heat and Mass Transfer, 2008
- Jet impingement quenching phenomena for hot surfaces well above the limiting temperature for solid–liquid contactInternational Journal of Heat and Mass Transfer, 2008
- EXPERIMENTAL STUDY OF COAXIAL ATOMIZERS SCALING. PART I: DENSE CORE ZONEAtomization and Sprays, 2007
- Maximum heat flux in relation to quenching of a high temperature surface with liquid jet impingementInternational Journal of Heat and Mass Transfer, 2006
- Analysis on film boiling heat transfer of impacting spraysInternational Journal of Heat and Mass Transfer, 1989
- Mechanisms of film boiling heat transfer of normally impacting sprayInternational Journal of Heat and Mass Transfer, 1987
- A calculation procedure for heat, mass and momentum transfer in three-dimensional parabolic flowsInternational Journal of Heat and Mass Transfer, 1972
- An experimental study of the dynamic behavior and heat transfer characteristics of water droplets impinging upon a heated surfaceInternational Journal of Heat and Mass Transfer, 1970
- Individual droplet heat-transfer rates for splattering on hot surfacesInternational Journal of Heat and Mass Transfer, 1969