Sensitivity Analysis of a Polyphase Wireless Power Transfer System Under Off-Nominal Conditions
- 7 December 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Transportation Electrification
- Vol. 10 (3) , 6690-6706
Abstract
Misaligned and/or variable coil airgaps cause coupling coefficient variation in wireless power transfer (WPT) systems, resulting in a decrease in the system’s transmitted power and efficiency. This paper presents sensitivity analyses of a three-phase, Y-Y connected, series-tuned WPT system in the frequency domain in terms of several different electric vehicle wireless charging off-nominal conditions (misalignments in Δ x and Δ y directions, change of airgap Δ z , and the roll Δψ, pitch Δθ, and yaw ΔΦ angles) as specified in Society of Automotive Engineers (SAE) J2954 Standard. Coil inductance matrices were obtained by measuring the self- and mutual inductances of the primary and secondary coil phase windings at variable airgap classes (from 5 cm to 30 cm) for five different charging positions as identified in SAE J2954. These 6 × 6 inductance matrices were used in sensitivity and Plexim/PLECS simulation analyses. The sensitivity of the WPT system was analyzed analytically using the input impedance and phase angle, voltage gain, current gain, quality factor, and coupling coefficient parameters of the series-tuned WPT system. The results were confirmed experimentally on a 50 kW WPT system.Keywords
Funding Information
- Vehicle Technologies Office, U.S. Department of Energy
- Scientific and Technological Research Council of Türkiye (TUBITAK) within the scope of 2219—International Postdoctoral Research Fellowship Program
This publication has 37 references indexed in Scilit:
- Modeling and Analysis of a Polyphase Wireless Power Transfer System for EV Charging Applications2022
- Constant output characteristics and design methodology of double side LC compensated capacitive power transferScientific Reports, 2022
- Wireless power transfer based on novel physical conceptsNature Electronics, 2021
- Three-Phase LCC-LCC Compensated 50-kW Wireless Charging System with Non-Zero Interphase Coupling2021
- Switched-Capacitor Tuning for Three-Phase Wireless Power Receiver Based on Perturbation and Observation MethodIEEE Access, 2021
- Power Stability Optimization Design of Three-Dimensional Wireless Power Transmission System in Multi-Load Application ScenariosIEEE Access, 2020
- Modeling, Design, and Experimental Verification of a WPT Level-3 Wireless Charger with Compact Secondary Coupler2019
- Analysis and designed of three-phase capacitive coupled wireless power transfer for high power charging system2018
- A novel wireless power transfer for in-motion EV/PHEV charging2013
- A bipolar primary pad topology for EV stationary charging and highway power by inductive coupling2011