On the estimation of error in measuring the residual stress by strain gauge rosette
Authors:
- A. GiriAGA. Giri
- C. PandeyCPC. Pandey
- M.M. MahapatraMMM.M. Mahapatra
- K. SharmaKSK. Sharma
- P.K. SinghPSP.K. Singh
- 1 April 2015
- journal article
- Published by Elsevier in Measurement
- Vol. 65, 41-49
Abstract
No abstract availableKeywords
Funding Information
- BRNS
- Bhabha Atomic Research Centre
- Indian Institute of Technology Roorkee
This publication has 10 references indexed in Scilit:
- Analysis of the effects of strain measurement errors on residual stresses measured by incremental hole-drilling methodThe Journal of Strain Analysis for Engineering Design, 2013
- Effects of plasticity on residual stresses measurement by hole drilling methodMechanics of Materials, 2012
- Experimental Verification of the Hole Drilling Plasticity Effect CorrectionMaterials Science Forum, 2011
- A procedure for evaluating high residual stresses using the blind hole drilling method, including the effect of plasticityThe Journal of Strain Analysis for Engineering Design, 2010
- Hole-Drilling Strain-Gauge Method: Residual Stress Measurement With Plasticity EffectsJournal of Engineering Materials and Technology, 2009
- Experimental and numerical study of measuring high welding residual stresses by using the blind-hole-drilling techniqueThe Journal of Strain Analysis for Engineering Design, 2008
- Local Stress-Ratio Criterion for Incremental Hole-Drilling Measurements of Shot-Peening StressesJournal of Engineering Materials and Technology, 2005
- Plastic Deformation during Application of the Hole-Drilling MethodMaterials Science Forum, 2000
- Error induced by local yielding around hole in hole drilling method for measuring residual stress of materialsMaterials Science and Technology, 1995
- Recent Developments in Center-hole Technique for Residual-stress MeasurementExperimental Techniques, 1982