ATCA digital controller hardware for vertical stabilization of plasmas in tokamaks
- 1 October 2006
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 77 (10) , 10F527
Abstract
The efficient vertical stabilization (VS) of plasmas in tokamaks requires a fast reaction of the VS controller, for example, after detection of edge localized modes (ELM). For controlling the effects of very large ELMs a new digital control hardware, based on the Advanced Telecommunications Computing Architecture™ (ATCA), is being developed aiming to reduce the VS digital control loop cycle (down to an optimal value of ) and improve the algorithm performance. The system has 1 ATCA™ processor module and up to 12 ATCA™ control modules, each one with 32 analog input channels ( resolution), 4 analog output channels ( resolution), and 8 digital input/output channels. The Aurora™ and PCI Express™ communication protocols will be used for data transport, between modules, with expected latencies below . Control algorithms are implemented on a ix86 based processor with and on field programmable gate arrays with , interconnected by serial gigabit links in a full mesh topology.
Keywords
This publication has 8 references indexed in Scilit:
- An FPGA-based multi-rate interpolator with real-time rate change for a JET test-bench systemIEEE Transactions on Nuclear Science, 2006
- JET real-time project test-bench software structureFusion Engineering and Design, 2006
- Position dependence of the unstable vertical movement of JET plasmas triggered by ELMsNuclear Fusion, 2005
- A test-bench for the real-time project phase 2 of JETFusion Engineering and Design, 2004
- A low cost, fully integrated, event-driven, real-time control and data acquisition system for fusion experimentsReview of Scientific Instruments, 2003
- A distributed, hardware reconfigurable and packet switched real-time control and data acquisition systemFusion Engineering and Design, 2002
- MHD control and ECCD in Compass-DPlasma Physics and Controlled Fusion, 1993
- Numerical study of displacement instability in elongated tokamakNuclear Fusion, 1974