All-polymer composites - a new approach with the use of disentangled semi-crystalline polymers. Part II. Preparation of composites from partially disentangled polylactide
Authors:
Open Access
- 1 April 2020
- journal article
- research article
- Published by LUKASIEWICZ Research Network - Industrial Chemistry Research Institute in Polimery
- Vol. 65 (04) , 261-267
Abstract
The mechanical properties of two uniaxially stretched polylactides have been studied: the polylactide with reduced density of entanglements of macromolecules and with equilibrium density of entanglements. It has been shown that plastic deformation is easier in a partially disentangled polymer. Thus, this polymer was used to form an all-polymer composite by blending it with a second molten polymer: poly(butylene succinate) or polystyrene. During mixing, polylactide fibers were produced that strengthened the prepared composite.Keywords
This publication has 9 references indexed in Scilit:
- Deformation of disentangled polypropylene crystalline grains into nanofibersJournal of Polymer Science Part B: Polymer Physics, 2016
- Single-polymer composites (SPCs): Status and future trendsComposites Science and Technology, 2014
- Thermovision studies of plastic deformation and cavitation in polypropyleneMechanics of Materials, 2013
- Development of self-reinforced polymer compositesProgress in Polymer Science, 2012
- Self-reinforced polymeric materials: A reviewProgress in Polymer Science, 2010
- Influence of molecular parameters on high-strain deformation of polyethylene in the plane-strain compression. Part I. Stress–strain behaviorPolymer, 2005
- Modification of physical properties of polylactidePolimery, 2005
- Toward understanding the stress oscillation phenomenon in polymers due to tensile impact loadingJournal of Materials Science, 2001
- A three-dimensional constitutive model for the large stretch behavior of rubber elastic materialsJournal of the Mechanics and Physics of Solids, 1993