Microstructure, Hardness, Tensile Strength, and Sliding Wear of Hypoeutectic Al–Si Cast Alloys with Small Cr Additions and Fe‐Impurity Content
- 24 February 2021
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 24 (8) , 2001552
Abstract
Herein, the influence of Cr additions on the solidification parameters, as‐cast microstructures, and mechanical properties of Al–Si alloys with Fe‐impurity is investigated. Al–Si–Cr alloys with 3% and 7% Si and 0.25% and 0.40% Cr are developed. Solidification experiments are performed using an instrumented cooling casting apparatus permitting the obtainment of vertical upward‐solidified ingots. The morphological and phase structures are characterized by optical and scanning electron microscopy and X‐ray diffractometry. Hardness, tensile, and dry sliding wear tests are conducted to determine the mechanical properties. The Cr addition to the Al–Si alloys leads to the formation of α‐Al(Si, Fe)Cr interdendritic precipitates, suppressing the formation of undesired needle‐like β‐intermetallic compounds (Al5FeSi). It is noted that both higher alloy Cr content and cooling rate induce refinement in the dendrite arm spacing, and improvement in both hardness and ultimate tensile strength when considering the alloys with identical Si content. The coefficient of friction slightly increases with increasing alloy Cr content and with coarsening of the microstructure. Correlations between the wear rate and secondary dendrite arm spacing are proposed, in which the wear rate decreases with decrease in the secondary dendrite arm spacing and increase in the alloy Cr content and hardness.Keywords
Funding Information
- Conselho Nacional de Desenvolvimento Científico e Tecnológico (403303/2016-8, 301600/2015-5)
- Financiadora de Estudos e Projetos (0082/16)
This publication has 41 references indexed in Scilit:
- The Effect of Major Alloying Elements on the Size of Secondary Dendrite Arm Spacing in the As-Cast Al-Si-Cu AlloysArchives of Foundry Engineering, 2012
- Study of the influence of copper and magnesium additions on the microstructure formation of Zn–Al hypoeutectic alloysJournal of Alloys and Compounds, 2009
- The influence of cooling rate and manganese content on the β-Al5FeSi phase formation and mechanical properties of Al–Si-based alloysMaterials Science and Engineering: A, 2008
- Mechanical properties as a function of microstructure and solidification thermal variables of Al–Si castingsMaterials Science and Engineering: A, 2006
- As-cast morphology of iron-intermetallics in Al–Si foundry alloysScripta Materialia, 2005
- Macrostructural and microstructural development in Al–Si alloys directionally solidified under unsteady-state conditionsJournal of Alloys and Compounds, 2004
- The effect of iron and manganese on the formation of intermetallic compounds in aluminum–silicon alloysMaterials Science and Engineering: A, 2004
- Growth related metastable phase selection in a 6xxx series wrought Al alloyMaterials Science and Engineering: A, 2001
- Effect of grain size on friction and wear of nanocrystalline aluminumMaterials Science and Engineering: A, 1996
- Material-specific wear mechanisms: relevance to wear modellingWear, 1990