Aerosol formation during foam application of non-volatile biocidal substances
Open Access
- 26 June 2023
- journal article
- research article
- Published by Oxford University Press (OUP) in Annals of Work Exposures and Health
- Vol. 67 (6) , 731-743
Abstract
The application of biocidal products by foam is considered an alternative to droplet spraying when disinfecting surfaces or fighting infestations. Inhalation exposure to aerosols containing the biocidal substances cannot be ruled out during foaming. In contrast to droplet spraying, very little is known about aerosol source strength during foaming. In this study, the formation of inhalable aerosols was quantified according to the aerosol release fractions of the active substance. The aerosol release fraction is defined as the mass of active substance transferred into inhalable airborne particles during foaming, normalised to the total amount of active substance released through the foam nozzle. Aerosol release fractions were measured in control chamber experiments where common foaming technologies were operated according to their typical conditions of use. These investigations include foams generated mechanically by actively mixing air with a foaming liquid as well as systems that use a blowing agent for foam formation. The values of the aerosol release fraction ranged from 3.4 × 10−6 to 5.7 × 10−3 (average values). For foaming processes based on mixing air and the foaming liquid, the release fractions could be correlated to the process and foam parameters such as foam exit velocity, nozzle dimensions, and foam expansion ratio.Keywords
Funding Information
- Federal Institute for Occupational Safety and Health
This publication has 9 references indexed in Scilit:
- Characterization of Aerosol Release during Spraying of Isocyanate ProductsAnnals of Work Exposures and Health, 2019
- New Biocide Foam Containing Hydrogen Peroxide for the Decontamination of Vertical Surface Contaminated With Bacillus thuringiensis SporesFrontiers in Microbiology, 2018
- Foam or spray application of agricultural chemicals to clean and disinfect layer cagesJournal of Applied Poultry Research, 2018
- Cleaning Products Fact Sheet: Default parameters for estimating consumer exposure: Updated version 20182018
- Thoracic and respirable aerosol fractions of spray products containing non-volatile compoundsJournal of Occupational and Environmental Hygiene, 2017
- Quantitative assessment of inhalation exposure and deposited dose of aerosol from nanotechnology-based consumer spraysEnvironmental Science: Nano, 2014
- Nanosized aerosols from consumer sprays: experimental analysis and exposure modeling for four commercial productsJournal of Nanoparticle Research, 2011
- Small-Scale Test Protocol for Firefighting Foams DEF(AUST)5706: Effect of Bubble Size Distribution and Expansion RatioFire Technology, 2010
- The Use of Foam Substances for DisinfectionIndoor and Built Environment, 2006