Microelectrochemical Aspects of Interstitial Carbon in Type 304 Stainless Steel: Improving Pitting Resistance at MnS Inclusion
Authors:
Open Access
- 27 February 2015
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 162 (6) , C270-C278
Abstract
Type 304 stainless steel was subjected to low-temperature carburizing treatment to add excess interstitial carbon to its surface. The average carbon concentration in the carburized layer was ca. 2.6 mass%, and the lattice parameter was expanded by ca. 2.5% without any carbide precipitation. No pitting was initiated on the carburized stainless steel in 0.1 M NaCl. Microscopic polarization measurements of a small area with a MnS inclusion were performed in NaCl and Na2SO4 solutions to clarify the mechanism of the improved resistance against pitting corrosion. The anodic polarization in 0.1 M NaCl and 0.1 M Na2SO4 demonstrated that the carburizing treatment has little or no effect on the electrochemical dissolution behavior of the MnS inclusions. However, from the anodic polarization of the steel in the solution that simulates the vicinity of the dissolved MnS inclusions in chloride-containing environments, it was clarified that the carburizing treatment inhibits the active dissolution rate of the steel matrix to about one hundredth. It would appear that interstitial carbon inhibits the dissolution rate of the steel, resulting in a reduction in the dissolution depth of the trenches at the MnS/steel boundaries. It is likely that the carburization resulted in a suppression of both the acidification due to the hydrolysis reaction of Cr3+ and the potential decrease due to IR-drop in the trenches to the extent that the corrosivity inside the trenches is insufficient for the localized transition from the passive to active state. Therefore, pit initiation does not occur at the MnS inclusions on the carburized stainless steel in chloride-containing environments.Keywords
This publication has 33 references indexed in Scilit:
- The composition of the boundary region of MnS inclusions in stainless steel and its relevance in triggering pitting corrosionCorrosion Science, 2005
- Use of the electrochemical microcell technique and the SVET for monitoring pitting corrosion at MnS inclusionsElectrochemistry Communications, 2004
- Pit Initiation at Single Sulfide Inclusions in Stainless SteelJournal of the Electrochemical Society, 2002
- Microelectrochemical Measurements of the Dissolution of Single MnS Inclusions, and the Prediction of the Critical Conditions for Pit Initiation on Stainless SteelJournal of the Electrochemical Society, 2001
- Pit Initiation on Stainless Steels in 1 M NaCl With and Without Mechanical StressJournal of the Electrochemical Society, 2001
- Pitting Corrosion of Metals: A Review of the Critical FactorsJournal of the Electrochemical Society, 1998
- A new microelectrochemical method to study pit initiation on stainless steelsElectrochimica Acta, 1997
- Micro- and nanotechniques to study localized corrosionElectrochimica Acta, 1995
- The initiation of pitting corrosion on austenitic stainless steel: on the role and importance of sulphide inclusionsCorrosion Science, 1992
- Effect of sulphide inclusions in a commercial stainless steel on the nucleation of corrosion pitsCorrosion Science, 1969