Mechanical and FEA-Assisted Characterization of 3D Printed Continuous Glass Fiber Reinforced Nylon Cellular Structures
Open Access
- 27 November 2021
- journal article
- research article
- Published by MDPI AG in Journal of Composites Science
- Vol. 5 (12) , 313
Abstract
The main objective of this study was to investigate the mechanical behavior of 3D printed fiberglass-reinforced nylon honeycomb structures. A Continuous Fiber Fabrication (CFF) 3D printer was used since it makes it possible to lay continuous strands of fibers inside the 3D printed geometries at selected locations across the width in order to optimize the bending behavior. Nylon and nylon/fiberglass honeycomb structures were tested under a three-point bending regime. The microstructure of the filaments and the 3D printed fractured surfaces following bending tests were examined with Scanning Electron Microscopy (SEM). The modulus of the materials was also evaluated using the nanoindentation technique. The behavior of the 3D printed structures was simulated with a Finite Element Model (FEM). The experimental and simulation results demonstrated that 3D printed continuous fiberglass reinforcement is possible to selectively adjust the bending strength of the honeycombs. When glass fibers are located near the top and bottom faces of honeycombs, the bending strength is maximized.Keywords
This publication has 31 references indexed in Scilit:
- Determination of the Mechanical Properties of Epoxy Silica Nanocomposites through FEA-Supported Evaluation of Ball Indentation Test ResultsMaterials Research, 2017
- Mechanical behavior of composited structure filled with tandem honeycombsComposites Part B: Engineering, 2017
- Experimental Study on Mechanical Properties of Single- and Dual-material 3D Printed ProductsProcedia Manufacturing, 2017
- Rapid prototyping of continuous carbon fiber reinforced polylactic acid composites by 3D printingJournal of Materials Processing Technology, 2016
- Evaluation and prediction of the tensile properties of continuous fiber-reinforced 3D printed structuresComposite Structures, 2016
- Bioinspired engineering of honeycomb structure – Using nature to inspire human innovationProgress in Materials Science, 2015
- Additive manufacturing of carbon fiber reinforced thermoplastic composites using fused deposition modelingComposites Part B: Engineering, 2015
- Behaviour of fibre-reinforced honeycomb core under low velocity impact loadingComposite Structures, 2013
- Nanoindentation measurements of fumed silica epoxy reinforced nanocompositesJournal of Reinforced Plastics and Composites, 2012
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992