LKB-Based Evaporation Duct Model Comparison with Buoy Data
Authors:
- Steven M. BabinSBSteven M. Babin
- G. Daniel DockeryGDG. Daniel Dockery
Open Access
- 1 April 2002
- journal article
- Published by American Meteorological Society in Journal of Applied Meteorology and Climatology
- Vol. 41 (4) , 434-446
Abstract
A wave-riding catamaran with a mast-traveling sensor package (profiling buoy) was developed to make fine-scale atmospheric measurements within the first meter above the ocean surface. These measurements are used to generate time-averaged modified refractivity (M) profiles that are then compared with those determined from four evaporation duct models based on the surface layer theory of Liu, Katsaros, and Businger (LKB). Model inputs are derived from measurements from masts on the R/V Chessie and from a tethered sea surface temperature buoy. Because electromagnetic propagation is critically dependent on the M-profile slopes, different analytical techniques are employed to compare the curvature of the model profiles with that of the profiles measured by the profiling buoy. One comparison criterion was to use the rms M slope difference between the model and a curve fit to the buoy profile data. Another analytical technique was to use the rms M difference after mean M removal between the model and th... Abstract A wave-riding catamaran with a mast-traveling sensor package (profiling buoy) was developed to make fine-scale atmospheric measurements within the first meter above the ocean surface. These measurements are used to generate time-averaged modified refractivity (M) profiles that are then compared with those determined from four evaporation duct models based on the surface layer theory of Liu, Katsaros, and Businger (LKB). Model inputs are derived from measurements from masts on the R/V Chessie and from a tethered sea surface temperature buoy. Because electromagnetic propagation is critically dependent on the M-profile slopes, different analytical techniques are employed to compare the curvature of the model profiles with that of the profiles measured by the profiling buoy. One comparison criterion was to use the rms M slope difference between the model and a curve fit to the buoy profile data. Another analytical technique was to use the rms M difference after mean M removal between the model and th...Keywords
This publication has 12 references indexed in Scilit:
- Convective Profile Constants RevisitedBoundary-Layer Meteorology, 2000
- A New Model of the Oceanic Evaporation DuctJournal of Applied Meteorology and Climatology, 1997
- An improved impedance-boundary algorithm for Fourier split-step solutions of the parabolic wave equationIEEE Transactions on Antennas and Propagation, 1996
- Bulk parameterization of air‐sea fluxes for Tropical Ocean‐Global Atmosphere Coupled‐Ocean Atmosphere Response ExperimentJournal of Geophysical Research: Oceans, 1996
- Potential refractivity as a similarity variableBoundary-Layer Meteorology, 1992
- On the turbulent fluxes of buoyancy, heat and moisture at the air‐sea interface at low wind speedsJournal of Geophysical Research: Oceans, 1991
- A sensitivity study of weather data inaccuracies on evaporation duct height algorithmsRadio Science, 1991
- Flux Parameterization over Land Surfaces for Atmospheric ModelsJournal of Applied Meteorology and Climatology, 1991
- Modeling electromagnetic wave propagation in the troposphere using the parabolic equationIEEE Transactions on Antennas and Propagation, 1988
- Bulk Parameterization of Air-Sea Exchanges of Heat and Water Vapor Including the Molecular Constraints at the InterfaceJournal of the Atmospheric Sciences, 1979