Complex permittivity and anisotropy measurement of 3D-printed PLA at microwaves and millimeter-waves
- 1 September 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Abstract
The use of 3D-printing based on extrusion depositing technologies for electromagnetic applications (such as dielectric antenna design or human mimicking tissues) is increasing as a low cost alternative to other small-scale fabrication technologies. As a result, it is of utmost scientific interest to know the exact dielectric properties of commercially available printable materials, such as polylactide acid (PLA). The extrusion depositing process may originate an anisotropic behavior of the material permittivity especially at mm-waves. We investigate this plastic's complex permittivity across the microwave spectrum from 0.5 GHz to 20 GHz and at 40 GHz and 60 GHz. We propose a new indirect method for the complex permittivity determination at microwave frequencies based on a microstrip line with stubs and a superstrate. At 40 GHz and 60 GHz, the printed PLA samples are characterized using waveguide and open resonator methods. Results show that throughout the tested frequency range the dielectric constant along the normal direction to the printing surface is around 2.75±0.05 and tan δ = (1.1±0.2)×10 -2 . However, at least for the tested mm-wave bands, the dielectric constant along the parallel direction to the printing surface is around 2.96, corresponding to nearly 7% anisotropy.Keywords
This publication has 17 references indexed in Scilit:
- 3D Printed Waveguide Slot Array AntennasIEEE Access, 2016
- Wideband Implantable Antenna for Body-Area High Data Rate Impulse Radio CommunicationIEEE Transactions on Antennas and Propagation, 2016
- Ball Grid Array-Module With Integrated Shaped Lens for WiGig Applications in Eyewear DevicesIEEE Transactions on Antennas and Propagation, 2016
- A Graphical Aid for the Complex Permittivity Measurement at Microwave and Millimeter WavelengthsIEEE Microwave and Wireless Components Letters, 2014
- Miniature Implantable Antennas for Biomedical Telemetry: From Simulation to RealizationIEEE Transactions on Biomedical Engineering, 2012
- S-parameter broad-band measurements on-microstrip and fast extraction of the substrate intrinsic propertiesIEEE Microwave and Wireless Components Letters, 2001
- S-parameter broadband measurements on-coplanar and fast extraction of the substrate intrinsic propertiesIEEE Microwave and Wireless Components Letters, 2001
- An accurate broadband measurement of substrate dielectric constantIEEE Microwave and Guided Wave Letters, 1996
- Two Methods for the Measurement of Substrate Dielectric ConstantIEEE Transactions on Microwave Theory and Techniques, 1987
- Dielectric measurements with an open-ended coaxial probeIEE Proceedings H Microwaves, Antennas and Propagation, 1987