Finite Element Analysis and In-Situ Measurement of Out-of-Plane Distortion in Thin Plate TIG Welding
Open Access
Abstract
Transient distortion of thin plate in the welding process usually has a complicated mode and large magnitude. Quantitative measurement and prediction of full-field distortion are challenging and rarely reported up to now. In this study, the out-of-plane distortion of a thin plate during the Tungsten Inert Gas (TIG) welding process was measured using the digital image correlation (DIC) method. A simulation model based on thermal elastic–plastic finite element method (FEM) and DIC measured geometric imperfection were developed for accurate prediction of the transient welding distortion. The numerical results and experimental data agreed very well in both out-of-plane deformation modes and magnitudes of the plate at different stages of welding. The maximum out-of-plane distortion was larger than 4 mm during welding which can cause instability of arc length and heat input. The distance change between welding torch and plate surface was investigated under different initial deflections of the plate before welding. The plate with flat geometry shows the minimum transient and final gap change. In addition, the relationship between heat input and welding distortion was clarified through a series of numerical analyses. Optimization of welding heat input can be performed based on numerical results to avoid excessive welding distortion.Keywords
This publication has 33 references indexed in Scilit:
- Development of in situ measurement system for welding deformation using digital camerasScience and Technology of Welding and Joining, 2012
- Influences of mesh density and transformation behavior on the result quality of numerical calculation of welding induced distortionSimulation Modelling Practice and Theory, 2011
- Study on the Technologies of Rapid Three-Dimension Optical Measurement for Welding Deformation of Sheet MaterialsAdvanced Materials Research, 2010
- A Study on the Buckling in Fillet Welds of SheetsJournal of Welding and Joining, 2009
- FEM prediction of buckling distortion induced by welding in thin plate panel structuresComputational Materials Science, 2008
- Numerical and experimental investigations on the residual stresses of the butt-welded jointsComputational Materials Science, 2004
- Numerical simulation of the laser welding process in butt-joint specimensJournal of Materials Processing Technology, 2003
- Experimental study of the phase transformation plasticity of 16MND5 low carbon steel under multiaxial loadingInternational Journal of Plasticity, 2002
- The influence of the fabrication process on the buckling of thin-walled steel box sectionsThin-Walled Structures, 2002
- Estimation of residual stresses in weldments using adaptive gridsComputers & Structures, 1996