Investigation into Effect of Tool Wear on Drilling Force and Surface Finish While Dry Drilling Aluminum 2024
- 1 July 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 548, 387-392
Abstract
Dry drilling of aluminum is environmentally friendly machining technique; in the meanwhile it is difficult to carry out due to aluminums gummy behavior and its tendency to adhere to cutting tools which diminishes hole quality. In spite of recent developments in cutting tool technology, HSS tools are still a cost effective choice due to relatively high toughness and feasibility to manufacture complex geometries of HSS drills besides its low price, make this tool a common choice for drilling soft materials such as aluminum. In this study effect of tool wear on thrust force and torque analyzed and hole quality assessed with respect to tool wear along tool life. Dry drilling on aluminum 2024, performed using HSS and HSCo drills at constant feed rate of 0.04 mm/rev and two cutting speeds of 28 and 94 m/min. Results revealed that the abrasive wear on flank face and BUE on chisel edge, margin and cutting lips were dominant mechanisms in all drills. It was found that with propagating the wear land on tool, thrust force and torque increased in both tools.Keywords
This publication has 8 references indexed in Scilit:
- Effect of machining parameters and coating on wear mechanisms in dry drilling of aluminium alloysInternational Journal of Machine Tools and Manufacture, 2005
- Extracting cutting force coefficients from drilling experimentsInternational Journal of Machine Tools and Manufacture, 2005
- The use of soft/lubricating coatings when dry drilling BS L168 aluminium alloySurface and Coatings Technology, 2004
- Relationship between cutting force and PCD cutting tool wear in machining silicon carbide reinforced aluminiumJournal of Materials Processing Technology, 2000
- Dry machining: Machining of the futureJournal of Materials Processing Technology, 2000
- Heat in metal cutting2000
- New hard/lubricant coating for dry machiningSurface and Coatings Technology, 1999
- Reviews of: “TOOL AND MANUFACTURING ENGINEERS HANDBOOK (THEH) VOLUME 1: MACHINING” Edited by Thomas Drozda and Charles Wick Society of Manufacturing Engineers One SME Drive, Dearborn, Michigan 48121 1983, 4th edition, 1484 pages, hardcover, price not given.Materials and Manufacturing Processes, 1989