Modelling the influence of velocity on wet friction-element friction in clutches
Authors:
- 8 January 2018
- journal article
- research article
- Published by Emerald Publishing in Industrial Lubrication and Tribology
- Vol. 70 (1) , 42-50
Abstract
Purpose: This study aims to establish a friction coefficient model relative to the rotation speed of a wet clutch engagement, which can predict friction coefficient under different stages of slipping velocity and different load pressures. In particular, the model has been improved by accounting the speed effect for the perdition of wet friction-element boundary friction, which is significant for understanding the friction mechanisms and for supporting the development of more efficient and related products. Design/methodology/approach: This research investigated the mechanism of wet friction in a wet clutch engagement. A mixed friction model is established based on the asperity model and Newton’s law of viscosity. To obtain a friction coefficient computed by the model, the normal load shared by both asperities and lubrication fluid needs to be determined. Therefore, rough surface contact mechanism is analysed; a surface topography model is established; and surface parameters are obtained by means of surface topography measurement and reconstruction. Finally, verification of the mixed friction model is achieved. Findings: Friction will be generated by both the asperity contact and the lubrication film shear relative to the rotation speed. And, the higher the relative speed, the larger the shearing power of lubrication film. It is caused by decrease in contact area of asperity. Surface morphology of a sintered bronze friction disk was obtained by a Laser-Micro-Test. The predicted results by the established model show that the total friction coefficient slightly reduced and then increased suddenly with speed. The surface topography model is responsible for the nonlinear behaviour of the asperity friction. Results of the simulation model are in agreement with those of the wet clutch engagement experiments. Originality/value: This research is original and it is supported by the national defence project. The wet friction element which is applied on tracked vehicles is analysed for the first time. Through the model, the trend of the friction coefficient can be more accurately predicted. The problem of the wet friction plate modelling difficult is solved by using the mixed friction model.Keywords
This publication has 11 references indexed in Scilit:
- Friction mechanism and lock-up friction coefficient prediction for sinter bronze friction materialsIndustrial Lubrication and Tribology, 2014
- Elastic contact between randomly rough surfaces: Comparison of theory with numerical resultsPhysical Review B, 2002
- Optimizing the Smoothness and Temperatures of a Wet Clutch Engagement Through Control of the Normal Force and Drive TorqueJournal of Tribology, 1999
- Finite Element Modeling of Engagement of Rough and Grooved Wet ClutchesJournal of Tribology, 1996
- The role of friction film in friction, wear and noise of automotive brakesWear, 1991
- The Mechanism of Friction in Boundary LubricationJournal of Tribology, 1985
- The elastic contact of a rough surfaceWear, 1975
- Boundary conditions at a naturally permeable wallJournal of Fluid Mechanics, 1967
- Contact of nominally flat surfacesProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1966
- Lubrication of Metal Surfaces by Fatty AcidsNature, 1945