Effect of Valve‐Closure Schedule on Water Hammer
Authors:
- 1 October 1986
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 112 (10) , 890-903
Abstract
The computerized method of chacteristics was used to analyze, for a single pipeline discharging into free air, the effect of valve‐closure schedule on water hammer under turbulent friction conditions. The inherent valve schedule was assumed to be a simple continuous power function of the fraction of the closing time, this function yielding a variety of standard valve configurations. A chart is presented to determine the valve schedule that should be used to yield minimum water hammer pressure. With the exception of the minimum pressure case, the same water hammer strength can be obtained with two different schedules. This follows from the type of schedule function used and from the compatibility equations of unsteady flow through closed conduits. Also, it was found that cavitation is less serious for an inherent valve schedule in which the bulk of the pressure surge occurs during the second part rather than during the first part of valve‐closure.Keywords
This publication has 6 references indexed in Scilit:
- Waterhammer Caused by Valve Stroking in a Pipe Line with Two ValvesBulletin of JSME, 1975
- Valve Stroking in Separated Pipe FlowJournal of the Hydraulics Division, 1974
- Discussion of “Water-Hammer Charts for Various Types of Valves”Journal of the Hydraulics Division, 1974
- Water-Hammer Charts for Various Types of ValvesJournal of the Hydraulics Division, 1973
- Valve Stroking for Complex Piping SystemsJournal of the Hydraulics Division, 1967
- Valve Stroking to Control Water HammerJournal of the Hydraulics Division, 1963