Comparison of residual stresses in TiFe hydrogen storage alloy measured by X-ray sin2Ψ and focused ion beam digital image correlation techniques
Authors:
- V.A. DorofeevaVDV.A. Dorofeeva
- Vladislav ZadorozhnyyVZVladislav Zadorozhnyy
- Artem KorolAKArtem Korol
- E.S. StatnikESE.S. Statnik
- M.YU. ZadorozhnyyMZM.YU. Zadorozhnyy
- A.M. KorsunskyAKA.M. Korsunsky
- Sergei D. KaloshkinSKSergei D. Kaloshkin
- Elena BerdonosovaEBElena Berdonosova
- M.V. LototskyyMLM.V. Lototskyy
- M.W. DavidsMDM.W. Davids
- S. PasupathiSPS. Pasupathi
- Semen KlyamkinSemen Klyamkin
Preprint
- 6 August 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
TiFe alloys are lower-cost alternatives to LaNi5-type hydride-forming materials which can absorb hydrogen at near room temperature and relatively low pressure. Accordingly, the hydrogen storage alloys on the basis of TiFe are promising in various energy storage applications. However, their use is hindered by a number of factors. In addition to difficult activation, these factors include hydrogen-induced mechanical degradation. During hydrogenation, the crystal lattice volume of TiFe increases by about 18% that can promote cracking, embrittlement and hydrogen-induced pulverization. As such, the durability of hydrogen storage materials on the basis of TiFe is strongly affected by internal stresses formed before and during hydrogenation.,In this work, the internal stress state of an arc-melted single phase TiFe alloy was studied using phase analysis, hydrogenation measurements and local stress mapping. Residual stresses were measured by focused ion beam digital image correlation (FIB-DIC) using micro-ring ion etching. The as-cast plate showed a non-uniform stress field in the XoY plane, with tensile and compressive regions. The compressive stresses did not exceed 500 MPa. After partial hydrogenation, only compressive stresses were detected, with the maximum magnitude at 200 μm. This behavior is related to preferential hydrogen uptake in the near-surface layer. Its expansion is constrained by the less affected bulk, which leads to compressive internal stresses. The results support durability-oriented design of porous TiFe-based metal-hydride structures.Keywords
This publication has 41 references indexed in Scilit:
- Gas-phase applications of metal hydridesJournal of Energy Storage, 2023
- A State-of-The-Art Review on the Latest trends in Hydrogen production, storage, and transportation techniquesFuel, 2023
- Microstructural evolution and corrosion behavior of Al25Ti25Ga25Be25 equi‐molar composition alloyMaterials and Corrosion, 2013
- Metal hydride materials for solid hydrogen storage: A review☆International Journal of Hydrogen Energy, 2007
- Introduction to Focused Ion Beams2005
- Hydrogen sorption peculiarities in FeTi-type TiFeVMn alloysJournal of Alloys and Compounds, 1993
- Orthorhombic structure of γ-TiFeD≈2Journal of the Less Common Metals, 1987
- Effect of sulphur addition on the properties of FeTi alloy for hydrogen storageJournal of the Less Common Metals, 1984
- Storing energy in metal hydrides: a review of the physical metallurgyJournal of Materials Science, 1983
- Hydrogen storage in FeTi: Surface segregation and its catalytic effect on hydrogenation and structural studies by means of neutron diffractionInternational Journal of Hydrogen Energy, 1979