Buckling and Postbuckling of a Delaminated Composite Beam in Bending
Authors:
- 1 March 2011
- journal article
- research article
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 49 (3) , 670-672
Abstract
A study was conducted to model the thin delaminated layer using the Elastica theory and investigate the postbuckling behavior for a delaminated beam under compression. Static tests were performed to understand the buckling and propagation behavior of 16-ply, laminated beams with a through-width delamination created by a polytetrafluoroethylene (PTFE) layer of 0.02 mm thickness and 40 mm length placed at the mid length of the beam between the second and third ply. A unidirectional plate made of M21-T800 carbon material was laid up and cured using an autoclave. An INSTRON-1332 servo-hydraulic machine with 10 kN load cell was used for loading application. The strain gauges and loading channel from the servo-hydraulic machine were connected to a SPIDER-8 data acquisition system which was attached to a PC. The specimens were also loaded through a four point bending fixture under displacement controlKeywords
This publication has 6 references indexed in Scilit:
- A low-dimensional model for delamination in a laterally loaded composite beam: Theory and experimentInternational Journal of Non-Linear Mechanics, 2008
- Nonlinear Modeling of Delaminated StrutsAIAA Journal, 2004
- Approximate Analysis of the Buckling Behavior of Composites with DelaminationJournal of Composite Materials, 2003
- The Initial Post-buckling and Growth Behavior of Internal Delaminations in Composite PlatesJournal of Applied Mechanics, 1993
- Snap buckling of delaminated composites under pure bendingComposites Science and Technology, 1990
- One dimensional modelling of failure in laminated plates by delamination bucklingInternational Journal of Solids and Structures, 1981