Effect of Roughness Parameter and Grinding Angle on Coefficient of Friction When Sliding of Al–Mg Alloy Over EN8 Steel
Authors:
- KishoreKIKishore
- Satish V. KailasSKSatish V. Kailas
- 29 April 2006
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 128 (4) , 697-704
Abstract
Surface topography of harder mating surface plays an important role in metal forming operations as it predominantly controls the frictional behavior at the interface. In the present investigation, an inclined scratch tester was used to understand the effect of direction of surface grinding marks on interface friction and transfer layer formation. EN8 steel flats were ground to attain different surface roughnesses with unidirectional grinding marks. Al–Mg alloy pins were then scratched against the prepared EN8 steel flats. The grinding angle (angle between direction of scratch and grinding marks) was varied between 0 deg and 90 deg during the scratch tests. Scanning electron micrography of the contact surfaces revealed the transfer layer morphology. The coefficient of friction and transfer layer formation were observed to depend primarily on the direction of grinding marks of the harder mating surface, and independent of the surface roughness of harder mating surface. The grinding angle effect was attributed to the variation of plowing component of friction with grinding angle.Keywords
This publication has 21 references indexed in Scilit:
- Roughness parametersJournal of Materials Processing Technology, 2002
- Investigation of the overall friction coefficient in single-pass scratch testWear, 2002
- A study of surface topography, friction and lubricants in metalformingInternational Journal of Machine Tools and Manufacture, 2000
- Experimental Characterization of Sliding Friction: Crossing From Deformation to Plowing ContactJournal of Tribology, 2000
- Experimental investigation of sliding friction between hard and deformable surfaces with application to manufacturing processesWear, 1999
- Effect of die surface topography on die-work interfacial friction in open die forgingInternational Journal of Machine Tools and Manufacture, 1992
- A Study of the Relative Surface Conformity Between Two Surfaces in Sliding ContactJournal of Tribology, 1991
- Friction measurement by using a scratch test methodWear, 1989
- Ball Bearing Lubrication (The Elastohydrodynamics of Elliptical Contacts)Journal of Lubrication Technology, 1982
- The Friction and Lubrication of SolidsAmerican Journal of Physics, 1951