Microstructure and Mechanical Properties of Ti-6Al-4V Alloy Samples Fabricated by Selective Laser Melting
- 11 May 2018
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 770, 179-186
Abstract
Ti-6Al-4V (wt%) alloy samples with dog-bone and box shapes respectively were fabricated by selective laser melting (SLM). The microstructures and mechanical properties of the 3D printed Ti-6Al-4V samples with and without heat treatment were characterized and tested. The microstructures of the as-fabricated dog-bone shaped samples were mainly composed of acicular α’ phase. After annealing at 700°C, the acicular α’ phase changed into an α/β lamellar structure. After solution treatment at 955°C, water quenching and aging at 550°C, the microstructure was mainly composed of primary α phase and α/β lamellar structure. The optimum heat treatment is annealing, and the mechanical properties of the annealed sample are as follows: yield strength: 1015 MPa, ultimate tensile strength (UTS): 1083 MPa and elongation to fracture: 7.9%. The microstructures of the box-shaped samples after annealing mainly consist of α phase and α/β lamellar structure. When stretched along the direction parallel to the crystal growth direction, the yield strength and UTS of the sample are 1054 and 1090 MPa,and its elongation to fracture is 6.3%. When stretched along the direction perpendicular to the crystal growth direction, the yield strength and UTS of the sample are 1019 and 1068 MPa respectively, and its elongation to fracture is 8.7%.Keywords
This publication has 6 references indexed in Scilit:
- Additive manufacturing and postprocessing of Ti-6Al-4V for superior mechanical propertiesMRS Bulletin, 2016
- Specific heat treatment of selective laser melted Ti–6Al–4V for biomedical applicationsFrontiers of Materials Science, 2015
- Additive manufacturing of strong and ductile Ti–6Al–4V by selective laser melting via in situ martensite decompositionActa Materialia, 2015
- Laser additive manufacturing of metallic components: materials, processes and mechanismsInternational Materials Reviews, 2012
- Fabrication of Metal and Alloy Components by Additive Manufacturing: Examples of 3D Materials ScienceJournal of Materials Research and Technology, 2012
- A study of the microstructural evolution during selective laser melting of Ti–6Al–4VActa Materialia, 2010