ANALYSIS OF CRACK TIP HYDROGEN DISTRIBUTION UNDER I/II MIXED MODE LOADS
Authors:
- 1 October 1994
- journal article
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 17 (10) , 1213-1220
Abstract
Abstract— The distribution of hydrogen in the vicinity of a crack tip was studied using SIMS (Secondary Ion Mass Spectrometry) under different ratios of I/II mixed mode loads. Modified WOL specimens with kinked slits were employed in the course of the experimental work. Spectrographic measurements show that under I/II mixed mode loading, both in the HIC and in the rmaxp directions, there are two hydrogen accumulation peaks ahead of the crack tip, corresponding to the location of the maximum hydrostatic stress and maximum equivalent plastic strain, respectively. Based on results obtained over a range of loading conditions from mode I to a high KII/ KI, ratio, it is shown that the mode II component has a clear influence on both peaks. The conditions for hydrogen redistribution are discussed in terms of crack tip stress‐strain fields.Keywords
This publication has 5 references indexed in Scilit:
- A finite element study of the near crack tip deformation of a ductile material under mixed mode loadingJournal of the Mechanics and Physics of Solids, 1987
- Stress corrosion cracking in high strength steel under mode III loadingMetallurgical Transactions A, 1986
- Hydrogen adsorption at dislocations and cracks in FeActa Metallurgica, 1978
- Crack-morphological aspects in fracture mechanicsEngineering Fracture Mechanics, 1975
- Formulation of Stress (Strain)-induced Diffusion of Hydrogen and Its Solution by Computer-aided Finite Element MethodTransactions of the Iron and Steel Institute of Japan, 1975