FLAT SPOT EXPLORATION*
Authors:
- 1 September 1975
- journal article
- Published by Wiley in Geophysical Prospecting
- Vol. 23 (3) , 533-577
Abstract
The hydrocarbon‐brine contact produces a flat reflection, unconformable with the lithologic reflections from the trap boundaries, and over a limited area bounded by structural contours. When it can be reliably detected and mapped, the flat spot can provide (i) a reasonably unambiguous indication and areal extent of a reservoir and (ii) an estimate of reservoir thickness.The gas‐brine contact in thick reservoirs in offshore elastic sections is the easiest target. An example of gas mapping is presented in the paper. Other reservoirs represent a continuum of increasingly elusive targets.Increasing the range of applicability of flat spot exploration will require (i) increases in signal/noise and multiple ratio, increases in the three dimensional depth point density (or grid density), increased resolution and static and dynamic correction accuracy, and (ii) processing and interpretation aimed directly at flat spot mapping.Low relief structural and stratigraphic traps should provide the most attractive targets. The approach should be at least theoretically feasible, though not necessarily cost effective, for most major reservoirs with a well‐behaved hydrocarbon brine contact.Keywords
This publication has 7 references indexed in Scilit:
- Formation velocity and density; the diagnostic basics for stratigraphic trapsGeophysics, 1974
- Developments in seismic data processing and analysis (1968-1970)Geophysics, 1971
- Optimum multichannel velocity filtersGeophysics, 1968
- Teleseismic signal extractionProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1966
- A new data-processing technique for the elimination of ghost arrivals on reflection seismogramsGeophysics, 1964
- Wide-band velocity filtering; The Pie-Slice processGeophysics, 1963
- LES FILTRES EN EVENTAIL*Geophysical Prospecting, 1963