Seismic Performance of Precast Brick‐Engineered Cementitious Composite Panels in Confined Masonry
Authors:
- 9 May 2026
- journal article
- research article
- Published by Wiley in Earthquake Spectra
- Vol. 42 (2) , e70072
Abstract
The present study proposes a novel technique to prepare a precast wall panel where the single brick core was sandwiched between two layers of the engineered cementitious composite (ECC). This precast panel can further be integrated with the reinforced concrete (RC) confining elements. The study aimed to evaluate the performance of a precast wall panel under combined in‐plane (IP) and out‐of‐plane (OOP) loading. The ECC used in preparing the precast wall panel possessed 1.88% tensile strain capacity and 2.17 MPa tensile strength which was developed incorporating polyester fibers, Portland Pozzolana Cement (PPC), fly ash, and river sand. A two‐bay, half‐scale precast confined masonry (CM) wall, with a single‐brick‐thick masonry core and ECC layers on both sides, was tested. IP loading was applied using a servo‐hydraulic actuator, followed by OOP excitation on a unidirectional shaking table. The experimental results were compared with those from previous tests on a similar specimen without ECC layers to assess the contribution of ECC to the seismic performance of the wall. Results showed that the ECC layers significantly improved both IP and OOP performance. The IP strength of the CM wall with precast ECC panels increased by 2.45 times, with a significant enhancement in OOP stability. The system retained structural integrity throughout loading, with the ECC layer effectively suppressing brittle failure modes.Keywords
This publication has 27 references indexed in Scilit:
- Development of engineered cementitious composite with moderate tensile properties using polyester fibersConstruction and Building Materials, 2023
- Enhancing Flexural Strength of Unreinforced Masonry Members Using Cementitious Matrix-Based Composites2022
- Second-order effects in URM walls subjected to compression and out-of-plane bending: From numerical evaluation to proposal of design proceduresEngineering Structures, 2020
- Cyclic testing of unreinforced masonry walls retrofitted with engineered cementitious compositesConstruction and Building Materials, 2018
- A strain-hardening cementitious composites with the tensile capacity up to 8%Construction and Building Materials, 2017
- Experimental and analytical study to evaluate the effectiveness of an in-plane reinforcement for masonry walls using GFRP meshesConstruction and Building Materials, 2015
- In-plane strengthening of clay brick unreinforced masonry wallettes using ECC shotcreteEngineering Structures, 2014
- Mechanical properties and numerical modeling of Fabric Reinforced Cementitious Matrix (FRCM) systems for strengthening of masonry structuresComposite Structures, 2014
- Experimental and analytical investigation on bond between Carbon-FRCM materials and masonryComposites Part B: Engineering, 2013
- Seismic behaviour of confined masonry wallsEarthquake Engineering & Structural Dynamics, 1997